OpenCores
Home » All forums » OpenRISC » Is there the UART output ?
no use no use 1/1 no use no use
Is there the UART output ?
by strug on Feb 2, 2012 		strug
Posts: 25
Joined: Dec 31, 2009
Last seen: May 9, 2012
If i build the mcs file of ml501 orpsocv2 project and download it into the corresponding board,Can I see the uart output "Hello world" directly?
If not,how should I generate the result?
Thanks.

RE: Is there the UART output ?
by vlogaras on Feb 2, 2012 		vlogaras
Posts: 45
Joined: Aug 28, 2005
Last seen: Feb 8, 2012
Hi there,
you must first connect through your ucf file the tx and rx signals to the correct pins on your device. Have you done that?
RE: Is there the UART output ?
by strug on Feb 2, 2012 		strug
Posts: 25
Joined: Dec 31, 2009
Last seen: May 9, 2012
ya.Sure.
I have the ML505 development board.
The attachment is constraint file.

However,I can't see the compilation of uart.c in the boards/xilinx/ml501/syn/xst/bin/Makefie.
ml505.ucf (42 kb)
no use no use 1/1 no use no use
© copyright 1999-2012 OpenCores.org, equivalent to ORSoC AB, all rights reserved. OpenCores®, registered trademark.