OpenCores

ZTEX releases new Artix 7 FPGA Board with USB and DDR3 SDRAM

Source: http://www.ztex.de/usb-fpga-2/usb-fpga-2.13.e.html

ZTEX Releases USB-FPGA Module 2.13. Main Features of the new FPGA Board are:

* Four FPGA variants: XC7A35T (expected mid of 2014), XC7A50T (expected mid of 2014), XC7A75T (on stock) and XC7A100T (on stock)
* USB 2.0 interfaceg using Cypress CY7C68013A EZ-USB FX2 Microcontroller (100 pin version)
* External I/O connector with 100 General Purpose I/O's (GPIO)
* 256 MByte DDR3 SDRAM (16 Bit, 400 MHz, up to 1600 MByte/s data rate)
* 128 MBit on-board Flash memory (e.g. to store Bitstream)
* 128 Kbit EEPROM memory (e.g. to store the EZ-USB firmware)
* 2 Kbit MAC-EEPROM: contains a unique non erasable MAC-address and is used to store firmware settings
* On-Board power supply:
* Heat sink included

An powerful Open Source SDK is provided for rapid development.

By: Stefan, Ziegenbalg

© copyright 1999-2017 OpenCores.org, equivalent to ORSoC AB, all rights reserved. OpenCores®, registered trademark.