I2C controller core
about zhe code #33
Closed ivay opened this issue almost 12 years ago
ivay commented almost 12 years ago
In the code , I found that the signal sda_o is always set to '0'. WHY? The signal sda_oen is an enable signal ,but it is set to be equal to 'din'; In my opinion , the 'din' should be set to zhe 'sda_o'. Why do the code be written in the example?
uecasm commented over 11 years ago
No, it's correct as is. Read up on how the I2C bus works.
rherveille closed this about 11 years ago
© copyright 1999-2018 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.