OpenCores
URL https://opencores.org/ocsvn/minsoc/minsoc/trunk

Subversion Repositories minsoc

[/] [minsoc/] [branches/] [rc-1.0/] [doc/] [README.txt] - Diff between revs 40 and 48

Go to most recent revision | Show entire file | Details | Blame | View Log

Rev 40 Rev 48
Line 1... Line 1...
Welcome to MinSoC. In order to put the system up and running you still have to follow two steps.
Welcome to MinSoC.
 
 
1. Follow the INSTALL.pdf document found in this same directory. It will guide you to install the OpenCores modules which are part of the MinSoC system but not delivered with it. Furthermore, it will guide you to install the tools required to compile OpenRISC firmware and to connect to the system (upload and debug firmware).
In order to put the system up and running you should first visit MinSOC's Wiki
 
that can be found at (http://minsoc.wikaba.com). There, you will find guidance
 
to retrieve and install the required tools, simulate and synthesize the design,
 
and to run and debug the first firmware on your FPGA.
 
 
2. Follow the HOWTO.pdf document found in this same directory. This document guides you to compile MinSoC firmwares, to simulate the system running its firmware, and to synthesize the system to create a FPGA bitfile to configure your FPGA. Finally, it also guides you in running your first firmware on your FPGA.
IMPORTANT: By any arisen problems, doubts or special requirements, take a look
 
into the FAQ pages (also in this very Wiki). It includes possible adaptations
 
you can easily make to the system, for the most reported problems using MinSoC
 
and the Advanced Debug System, and even some tweak possibilities. If you have a
 
problem which is not described there or you cannot make it work, please send us
 
an email to minsoc@googlegroups.com .
 
 
IMPORTANT: By any arisen problems, doubts or special requirements, take a look into the FAQ.pdf document. It includes possible adaptations you can easily make to the system, most reported problems using MinSoC and the Advanced Debug System, and even some tweak possibilities. If you have a problem which is not described there or you cannot make it work, please start a thread about your problem on OpenRISC forum: http://opencores.org/forum,OpenRISC
FINALLY: My system is up and running, what do I do next? The real system
 
documentation is the minsoc.pdf document. It gives a thorough insight into
 
MinSoC, its goals, design and ideas. It helps you to better understand the
 
system and can give you a good idea of what to do next, after your system is up
 
and running.
 
 
FINALLY: My system is up and running, what do I do next? The real system documentation is the minsoc.pdf document. It gives a thorough insight into MinSoC, its goals, design and ideas. It helps you to better understand the system and can give you a good idea of what to do next, after your system is up and running.
 
 
 
I WANT TO TWEAK THINGS: check THESIS.txt
 
 No newline at end of file
 No newline at end of file
 
Enjoy your time

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.