URL
https://opencores.org/ocsvn/openrisc/openrisc/trunk
Subversion Repositories openrisc
[/] [openrisc/] [trunk/] [or1200/] [rtl/] [verilog/] [or1200_spram_64x14.v] - Rev 184
Go to most recent revision | Compare with Previous | Blame | View Log
////////////////////////////////////////////////////////////////////// //// //// //// Generic Single-Port Synchronous RAM //// //// //// //// This file is part of memory library available from //// //// http://www.opencores.org/cvsweb.shtml/generic_memories/ //// //// //// //// Description //// //// This block is a wrapper with common single-port //// //// synchronous memory interface for different //// //// types of ASIC and FPGA RAMs. Beside universal memory //// //// interface it also provides behavioral model of generic //// //// single-port synchronous RAM. //// //// It should be used in all OPENCORES designs that want to be //// //// portable accross different target technologies and //// //// independent of target memory. //// //// //// //// Supported ASIC RAMs are: //// //// - Artisan Single-Port Sync RAM //// //// - Avant! Two-Port Sync RAM (*) //// //// - Virage Single-Port Sync RAM //// //// - Virtual Silicon Single-Port Sync RAM //// //// //// //// Supported FPGA RAMs are: //// //// - Xilinx Virtex RAMB16 //// //// - Xilinx Virtex RAMB4 //// //// - Altera LPM //// //// //// //// To Do: //// //// - xilinx rams need external tri-state logic //// //// - fix avant! two-port ram //// //// - add additional RAMs //// //// //// //// Author(s): //// //// - Damjan Lampret, lampret@opencores.org //// //// //// ////////////////////////////////////////////////////////////////////// //// //// //// Copyright (C) 2000 Authors and OPENCORES.ORG //// //// //// //// This source file may be used and distributed without //// //// restriction provided that this copyright statement is not //// //// removed from the file and that any derivative work contains //// //// the original copyright notice and the associated disclaimer. //// //// //// //// This source file is free software; you can redistribute it //// //// and/or modify it under the terms of the GNU Lesser General //// //// Public License as published by the Free Software Foundation; //// //// either version 2.1 of the License, or (at your option) any //// //// later version. //// //// //// //// This source is distributed in the hope that it will be //// //// useful, but WITHOUT ANY WARRANTY; without even the implied //// //// warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR //// //// PURPOSE. See the GNU Lesser General Public License for more //// //// details. //// //// //// //// You should have received a copy of the GNU Lesser General //// //// Public License along with this source; if not, download it //// //// from http://www.opencores.org/lgpl.shtml //// //// //// ////////////////////////////////////////////////////////////////////// // // CVS Revision History // // $Log: or1200_spram_64x14.v,v $ // Revision 2.0 2010/06/30 11:00:00 ORSoC // Minor update: // Coding style changed. // // Revision 1.9 2005/10/19 11:37:56 jcastillo // Added support for RAMB16 Xilinx4/Spartan3 primitives // // Revision 1.8 2004/06/08 18:15:32 lampret // Changed behavior of the simulation generic models // // Revision 1.7 2004/04/05 08:29:57 lampret // Merged branch_qmem into main tree. // // Revision 1.3.4.1 2003/12/09 11:46:48 simons // Mbist nameing changed, Artisan ram instance signal names fixed, some synthesis waning fixed. // // Revision 1.3 2003/04/07 01:19:07 lampret // Added Altera LPM RAMs. Changed generic RAM output when OE inactive. // // Revision 1.2 2002/10/17 20:04:41 lampret // Added BIST scan. Special VS RAMs need to be used to implement BIST. // // Revision 1.1 2002/01/03 08:16:15 lampret // New prefixes for RTL files, prefixed module names. Updated cache controllers and MMUs. // // Revision 1.7 2001/11/02 18:57:14 lampret // Modified virtual silicon instantiations. // // Revision 1.6 2001/10/21 17:57:16 lampret // Removed params from generic_XX.v. Added translate_off/on in sprs.v and id.v. Removed spr_addr from dc.v and ic.v. Fixed CR+LF. // // Revision 1.5 2001/10/14 13:12:09 lampret // MP3 version. // // Revision 1.1.1.1 2001/10/06 10:18:36 igorm // no message // // Revision 1.1 2001/08/09 13:39:33 lampret // Major clean-up. // // Revision 1.2 2001/07/30 05:38:02 lampret // Adding empty directories required by HDL coding guidelines // // // synopsys translate_off `include "timescale.v" // synopsys translate_on `include "or1200_defines.v" module or1200_spram_64x14( `ifdef OR1200_BIST // RAM BIST mbist_si_i, mbist_so_o, mbist_ctrl_i, `endif // Generic synchronous single-port RAM interface clk, rst, ce, we, oe, addr, di, doq ); // // Default address and data buses width // parameter aw = 6; parameter dw = 14; `ifdef OR1200_BIST // // RAM BIST // input mbist_si_i; input [`OR1200_MBIST_CTRL_WIDTH - 1:0] mbist_ctrl_i; output mbist_so_o; `endif // // Generic synchronous single-port RAM interface // input clk; // Clock input rst; // Reset input ce; // Chip enable input input we; // Write enable input input oe; // Output enable input input [aw-1:0] addr; // address bus inputs input [dw-1:0] di; // input data bus output [dw-1:0] doq; // output data bus // // Internal wires and registers // `ifdef OR1200_XILINX_RAMB4 wire [1:0] unconnected; `else `ifdef OR1200_XILINX_RAMB16 wire [1:0] unconnected; `endif // !OR1200_XILINX_RAMB16 `endif // !OR1200_XILINX_RAMB4 `ifdef OR1200_ARTISAN_SSP `else `ifdef OR1200_VIRTUALSILICON_SSP `else `ifdef OR1200_BIST assign mbist_so_o = mbist_si_i; `endif `endif `endif `ifdef OR1200_ARTISAN_SSP // // Instantiation of ASIC memory: // // Artisan Synchronous Single-Port RAM (ra1sh) // `ifdef UNUSED art_hssp_64x14 #(dw, 1<<aw, aw) artisan_ssp( `else `ifdef OR1200_BIST art_hssp_64x14_bist artisan_ssp( `else art_hssp_64x14 artisan_ssp( `endif `endif `ifdef OR1200_BIST // RAM BIST .mbist_si_i(mbist_si_i), .mbist_so_o(mbist_so_o), .mbist_ctrl_i(mbist_ctrl_i), `endif .CLK(clk), .CEN(~ce), .WEN(~we), .A(addr), .D(di), .OEN(~oe), .Q(doq) ); `else `ifdef OR1200_AVANT_ATP // // Instantiation of ASIC memory: // // Avant! Asynchronous Two-Port RAM // avant_atp avant_atp( .web(~we), .reb(), .oeb(~oe), .rcsb(), .wcsb(), .ra(addr), .wa(addr), .di(di), .doq(doq) ); `else `ifdef OR1200_VIRAGE_SSP // // Instantiation of ASIC memory: // // Virage Synchronous 1-port R/W RAM // virage_ssp virage_ssp( .clk(clk), .adr(addr), .d(di), .we(we), .oe(oe), .me(ce), .q(doq) ); `else `ifdef OR1200_VIRTUALSILICON_SSP // // Instantiation of ASIC memory: // // Virtual Silicon Single-Port Synchronous SRAM // `ifdef UNUSED vs_hdsp_64x14 #(1<<aw, aw-1, dw-1) vs_ssp( `else `ifdef OR1200_BIST vs_hdsp_64x14_bist vs_ssp( `else vs_hdsp_64x14 vs_ssp( `endif `endif `ifdef OR1200_BIST // RAM BIST .mbist_si_i(mbist_si_i), .mbist_so_o(mbist_so_o), .mbist_ctrl_i(mbist_ctrl_i), `endif .CK(clk), .ADR(addr), .DI(di), .WEN(~we), .CEN(~ce), .OEN(~oe), .DOUT(doq) ); `else `ifdef OR1200_XILINX_RAMB4 // // Instantiation of FPGA memory: // // Virtex/Spartan2 // // // Block 0 // RAMB4_S16 ramb4_s16_0( .CLK(clk), .RST(1'b0), .ADDR({2'b00, addr}), .DI({2'b00, di[13:0]}), .EN(ce), .WE(we), .DO({unconnected, doq[13:0]}) ); `else `ifdef OR1200_XILINX_RAMB16 // // Instantiation of FPGA memory: // // Virtex4/Spartan3E // RAMB16_S18 ramb16_s18( .CLK(clk), .SSR(1'b0), .ADDR({4'b0000, addr}), .DI({2'b00, di[13:0]}), .DIP(2'b00), .EN(ce), .WE(we), .DO({unconnected, doq[13:0]}), .DOP() ); `else `ifdef OR1200_ALTERA_LPM // // Instantiation of FPGA memory: // // Altera LPM // // Added By Jamil Khatib // wire wr; assign wr = ce & we; initial $display("Using Altera LPM."); lpm_ram_dq lpm_ram_dq_component ( .address(addr), .inclock(clk), .outclock(clk), .data(di), .we(wr), .q(doq) ); defparam lpm_ram_dq_component.lpm_width = dw, lpm_ram_dq_component.lpm_widthad = aw, lpm_ram_dq_component.lpm_indata = "REGISTERED", lpm_ram_dq_component.lpm_address_control = "REGISTERED", lpm_ram_dq_component.lpm_outdata = "UNREGISTERED", lpm_ram_dq_component.lpm_hint = "USE_EAB=ON"; // examplar attribute lpm_ram_dq_component NOOPT TRUE `else // // Generic single-port synchronous RAM model // // // Generic RAM's registers and wires // reg [dw-1:0] mem [(1<<aw)-1:0]; // RAM content reg [aw-1:0] addr_reg; // RAM address register // // Data output drivers // assign doq = (oe) ? mem[addr_reg] : {dw{1'b0}}; // // RAM address register // always @(posedge clk or posedge rst) if (rst) addr_reg <= #1 {aw{1'b0}}; else if (ce) addr_reg <= #1 addr; // // RAM write // always @(posedge clk) if (ce && we) mem[addr] <= #1 di; `endif // !OR1200_ALTERA_LPM `endif // !OR1200_XILINX_RAMB16 `endif // !OR1200_XILINX_RAMB4 `endif // !OR1200_VIRTUALSILICON_SSP `endif // !OR1200_VIRAGE_SSP `endif // !OR1200_AVANT_ATP `endif // !OR1200_ARTISAN_SSP endmodule
Go to most recent revision | Compare with Previous | Blame | View Log