Subversion Repositories test_project

Firmware is required for this device: http://accessrunner.sourceforge.net/

While it is capable of managing/maintaining the ADSL connection without the
module loaded, the device will sometimes stop responding after unloading the
driver and it is necessary to unplug/remove power to the device to fix this.

Detected devices will appear as ATM devices named "cxacru". In /sys/class/atm/
these are directories named cxacruN where N is the device number. A symlink
named device points to the USB interface device's directory which contains
several sysfs attribute files for retrieving device statistics:

* adsl_controller_version

* adsl_headend
* adsl_headend_environment
        Information about the remote headend.

* downstream_attenuation (dB)
* downstream_bits_per_frame
* downstream_rate (kbps)
* downstream_snr_margin (dB)
        Downstream stats.

* upstream_attenuation (dB)
* upstream_bits_per_frame
* upstream_rate (kbps)
* upstream_snr_margin (dB)
* transmitter_power (dBm/Hz)
        Upstream stats.

* downstream_crc_errors
* downstream_fec_errors
* downstream_hec_errors
* upstream_crc_errors
* upstream_fec_errors
* upstream_hec_errors
        Error counts.

* line_startable
        Indicates that ADSL support on the device
        is/can be enabled, see adsl_start.

* line_status
        "initialising"
        "down"
        "attempting to activate"
        "training"
        "channel analysis"
        "exchange"
        "waiting"
        "up"

        Changes between "down" and "attempting to activate"
        if there is no signal.

* link_status
        "not connected"
        "connected"
        "lost"

* mac_address

* modulation
        "ANSI T1.413"
        "ITU-T G.992.1 (G.DMT)"
        "ITU-T G.992.2 (G.LITE)"

* startup_attempts
        Count of total attempts to initialise ADSL.

To enable/disable ADSL, the following can be written to the adsl_state file:
        "start"
        "stop
        "restart" (stops, waits 1.5s, then starts)
        "poll" (used to resume status polling if it was disabled due to failure)

Changes in adsl/line state are reported via kernel log messages:
        [4942145.150704] ATM dev 0: ADSL state: running
        [4942243.663766] ATM dev 0: ADSL line: down
        [4942249.665075] ATM dev 0: ADSL line: attempting to activate
        [4942253.654954] ATM dev 0: ADSL line: training
        [4942255.666387] ATM dev 0: ADSL line: channel analysis
        [4942259.656262] ATM dev 0: ADSL line: exchange
        [2635357.696901] ATM dev 0: ADSL line: up (8128 kb/s down | 832 kb/s up)