OpenCores
URL https://opencores.org/ocsvn/s6soc/s6soc/trunk

Subversion Repositories s6soc

[/] [s6soc/] [trunk/] [rtl/] [xoddr.v] - Rev 51

Compare with Previous | Blame | View Log

////////////////////////////////////////////////////////////////////////////////
//
// Filename: 	xoddr.v
//
// Project:	CMod S6 System on a Chip, ZipCPU demonstration project
//
// Purpose:	When outputting a clock, Xilinx recommends using the ODDR
//		primitive to insure the clock's stability.  This is a simple
//	wrapper around that primitive, although it does cost one delay.
//	For the QSPI, this helps to make certain that as much of the logic
//	delay as possible has been removed from the path--to get the full
//	80MHz speed of our clock.  (The QSPI device on the S6 can run at 108MHz,
//	here, we will run it at 80MHz.)
//
// Creator:	Dan Gisselquist, Ph.D.
//		Gisselquist Technology, LLC
//
////////////////////////////////////////////////////////////////////////////////
//
// Copyright (C) 2015-2017, Gisselquist Technology, LLC
//
// This program is free software (firmware): you can redistribute it and/or
// modify it under the terms of  the GNU General Public License as published
// by the Free Software Foundation, either version 3 of the License, or (at
// your option) any later version.
//
// This program is distributed in the hope that it will be useful, but WITHOUT
// ANY WARRANTY; without even the implied warranty of MERCHANTIBILITY or
// FITNESS FOR A PARTICULAR PURPOSE.  See the GNU General Public License
// for more details.
//
// You should have received a copy of the GNU General Public License along
// with this program.  (It's in the $(ROOT)/doc directory.  Run make with no
// target there if the PDF file isn't present.)  If not, see
// <http://www.gnu.org/licenses/> for a copy.
//
// License:	GPL, v3, as defined and found on www.gnu.org,
//		http://www.gnu.org/licenses/gpl.html
//
//
////////////////////////////////////////////////////////////////////////////////
//
//
module	xoddr(i_clk, i_v, o_pin);
	input	[1:0]	i_clk;
	input	[1:0]	i_v;
	output		o_pin;
 
	wire	w_internal;
	reg	last;
 
	ODDR2 #(
		.DDR_ALIGNMENT("C0"),
		.INIT(1'b1),
		.SRTYPE("ASYNC")
	) ODDRi(
		.Q(o_pin),
		.CE(1'b1),
		.C0(i_clk[0]),
		.D0(i_v[0]),	// Negative clock edge (goes first)
		.C1(i_clk[1]),
		.D1(i_v[1]),	// Positive clock edge
		.R(1'b0),
		.S(1'b0));
 
endmodule
 

Compare with Previous | Blame | View Log

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.