OpenCores
URL https://opencores.org/ocsvn/ethmac/ethmac/trunk

Subversion Repositories ethmac

[/] - Rev 266

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
266 Flow control test almost finished. mohor 7796d 22h /
265 This commit was manufactured by cvs2svn to create tag 'rel_13'. 7797d 02h /
264 Registers RxStatusWrite_rck and RxStatusWriteLatched were not used
anywhere. Removed.
mohor 7797d 02h /
263 test_mac_full_duplex_flow_control tests pretty much finished.
TEST 0: INSERT CONTROL FRM. WHILE TRANSMITTING NORMAL
FRM. AT 4 TX BD ( 10Mbps ) finished.
TEST 2: RECEIVE CONTROL FRAMES WITH PASSALL OPTION
TURNED OFF AT ONE RX BD ( 10Mbps ) finished.
mohor 7797d 14h /
262 Version 1.18 released.
MIIMRST (Reset of the MIIM module) not used any more in the MIIMODER
register. Control Frame bit (CF) added to the RX buffer descriptor. Control
frame detection section updated.
mohor 7797d 14h /
261 Rx Flow control fixed. CF flag added to the RX buffer descriptor. RxAbort
synchronized.
mohor 7797d 14h /
260 test_mac_full_duplex_flow test 0 finished. Sending the control (PAUSE) frame
finished.
mohor 7798d 02h /
259 In loopback rx_clk is not looped back. Possible CRC error. Consider if usage
of additional logic is necessery (FIFO for looping the data).
mohor 7798d 15h /
258 This commit was manufactured by cvs2svn to create tag 'rel_12'. 7798d 16h /
257 When TxUsedData and CtrlMux occur at the same time, byte counter needs
to be incremented by 2. Signal IncrementByteCntBy2 added for that reason.
mohor 7798d 16h /
256 TxDone and TxAbort changed so they're not propagated to the wishbone
module when control frame is transmitted.
mohor 7798d 16h /
255 TPauseRq synchronized to tx_clk. mohor 7798d 16h /
254 Temp version. mohor 7799d 19h /
253 r_MiiMRst is not used for resetting the MIIM module. wb_rst used instead. mohor 7799d 22h /
252 Just some updates. tadejm 7799d 22h /
251 When control frame (PAUSE) was sent, status was written in the
eth_wishbone module and both TXB and TXC interrupts were set. Fixed.
Only TXC interrupt is set.
mohor 7799d 22h /
250 AddressMiss status is connecting to the Rx BD. AddressMiss is identifying
that a frame was received because of the promiscous mode.
mohor 7799d 22h /
249 This commit was manufactured by cvs2svn to create tag 'rel_11'. 7800d 22h /
248 wb_rst_i is used for MIIM reset. mohor 7800d 22h /
247 This commit was manufactured by cvs2svn to create tag 'rel_10'. 7804d 01h /
246 Since r_Rst bit is not used any more, default value is changed to 0xa000. mohor 7804d 01h /
245 Rev 1.7. mohor 7804d 19h /
244 r_Rst signal does not reset any module any more and is removed from the design. mohor 7804d 21h /
243 Late collision is not reported any more. tadejm 7805d 03h /
242 Late collision is reported only when not in the full duplex.
Sample is taken (for status) as soon as MRxDV is not valid (regardless
of the received byte cnt).
tadejm 7805d 17h /
241 StartIdle state changed (not important the size of the packet).
StartData1 activates only while ByteCnt is smaller than the MaxFrame.
tadejm 7805d 17h /
240 All modules are reset with wb_rst instead of the r_Rst. Exception is MII module. tadejm 7805d 17h /
239 RxError is not generated when small frame reception is enabled and small
frames are received.
tadejm 7805d 18h /
238 Defines fixed to use generic RAM by default. mohor 7817d 22h /
237 This commit was manufactured by cvs2svn to create tag 'rel_9'. 7820d 03h /

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.