OpenCores
URL https://opencores.org/ocsvn/ethmac/ethmac/trunk

Subversion Repositories ethmac

[/] [ethmac/] [tags/] [rel_18/] - Rev 274

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
274 Backup version. Not fully working. tadejm 6110d 01h /ethmac/tags/rel_18/
272 When control packets were received, they were ignored in some cases. tadejm 6110d 07h /ethmac/tags/rel_18/
270 When receiving normal data frame and RxFlow control was switched on, RXB
interrupt was not set.
mohor 6111d 09h /ethmac/tags/rel_18/
269 When in full duplex, transmit was sometimes blocked. Fixed. mohor 6112d 09h /ethmac/tags/rel_18/
268 Release 1.19. Control frame description changed. mohor 6166d 02h /ethmac/tags/rel_18/
267 Full duplex control frames tested. mohor 6166d 04h /ethmac/tags/rel_18/
266 Flow control test almost finished. mohor 6171d 03h /ethmac/tags/rel_18/
264 Registers RxStatusWrite_rck and RxStatusWriteLatched were not used
anywhere. Removed.
mohor 6171d 07h /ethmac/tags/rel_18/
263 test_mac_full_duplex_flow_control tests pretty much finished.
TEST 0: INSERT CONTROL FRM. WHILE TRANSMITTING NORMAL
FRM. AT 4 TX BD ( 10Mbps ) finished.
TEST 2: RECEIVE CONTROL FRAMES WITH PASSALL OPTION
TURNED OFF AT ONE RX BD ( 10Mbps ) finished.
mohor 6171d 19h /ethmac/tags/rel_18/
262 Version 1.18 released.
MIIMRST (Reset of the MIIM module) not used any more in the MIIMODER
register. Control Frame bit (CF) added to the RX buffer descriptor. Control
frame detection section updated.
mohor 6171d 19h /ethmac/tags/rel_18/
261 Rx Flow control fixed. CF flag added to the RX buffer descriptor. RxAbort
synchronized.
mohor 6171d 19h /ethmac/tags/rel_18/
260 test_mac_full_duplex_flow test 0 finished. Sending the control (PAUSE) frame
finished.
mohor 6172d 07h /ethmac/tags/rel_18/
259 In loopback rx_clk is not looped back. Possible CRC error. Consider if usage
of additional logic is necessery (FIFO for looping the data).
mohor 6172d 20h /ethmac/tags/rel_18/
257 When TxUsedData and CtrlMux occur at the same time, byte counter needs
to be incremented by 2. Signal IncrementByteCntBy2 added for that reason.
mohor 6172d 21h /ethmac/tags/rel_18/
256 TxDone and TxAbort changed so they're not propagated to the wishbone
module when control frame is transmitted.
mohor 6172d 21h /ethmac/tags/rel_18/
255 TPauseRq synchronized to tx_clk. mohor 6172d 21h /ethmac/tags/rel_18/
254 Temp version. mohor 6174d 00h /ethmac/tags/rel_18/
253 r_MiiMRst is not used for resetting the MIIM module. wb_rst used instead. mohor 6174d 03h /ethmac/tags/rel_18/
252 Just some updates. tadejm 6174d 03h /ethmac/tags/rel_18/
251 When control frame (PAUSE) was sent, status was written in the
eth_wishbone module and both TXB and TXC interrupts were set. Fixed.
Only TXC interrupt is set.
mohor 6174d 03h /ethmac/tags/rel_18/

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2019 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.