Subversion Repositories ethmac

[/] [ethmac/] [tags/] [rel_26/] [rtl/] - Rev 285


Go to most recent revision | Details | Compare with Previous | Blame

Filtering Options

Clear current filter

Rev Log message Author Age Path
285 Binary operator used instead of unary (xnor). mohor 7168d 19h /ethmac/tags/rel_26/rtl
284 Busy was set 2 cycles too late. Reported by Dennis Scott. mohor 7196d 20h /ethmac/tags/rel_26/rtl
283 RxBDAddress was updated also when value to r_TxBDNum was written with
greater value than allowed.
mohor 7224d 14h /ethmac/tags/rel_26/rtl
280 Reset has priority in some flipflops. mohor 7302d 15h /ethmac/tags/rel_26/rtl
278 A new bug (entered with previous update) fixed. When abort occured sometimes
data transmission was blocked.
mohor 7302d 16h /ethmac/tags/rel_26/rtl
277 When padding was enabled and crc disabled, frame was not ended correctly. mohor 7302d 16h /ethmac/tags/rel_26/rtl
276 Defer indication changed. tadejm 7302d 16h /ethmac/tags/rel_26/rtl
275 Fix MTxErr or prevent sending too big frames. mohor 7309d 21h /ethmac/tags/rel_26/rtl
272 When control packets were received, they were ignored in some cases. tadejm 7310d 16h /ethmac/tags/rel_26/rtl
270 When receiving normal data frame and RxFlow control was switched on, RXB
interrupt was not set.
mohor 7311d 18h /ethmac/tags/rel_26/rtl
269 When in full duplex, transmit was sometimes blocked. Fixed. mohor 7312d 18h /ethmac/tags/rel_26/rtl
264 Registers RxStatusWrite_rck and RxStatusWriteLatched were not used
anywhere. Removed.
mohor 7371d 17h /ethmac/tags/rel_26/rtl
261 Rx Flow control fixed. CF flag added to the RX buffer descriptor. RxAbort
mohor 7372d 04h /ethmac/tags/rel_26/rtl
259 In loopback rx_clk is not looped back. Possible CRC error. Consider if usage
of additional logic is necessery (FIFO for looping the data).
mohor 7373d 05h /ethmac/tags/rel_26/rtl
257 When TxUsedData and CtrlMux occur at the same time, byte counter needs
to be incremented by 2. Signal IncrementByteCntBy2 added for that reason.
mohor 7373d 06h /ethmac/tags/rel_26/rtl
256 TxDone and TxAbort changed so they're not propagated to the wishbone
module when control frame is transmitted.
mohor 7373d 06h /ethmac/tags/rel_26/rtl
255 TPauseRq synchronized to tx_clk. mohor 7373d 06h /ethmac/tags/rel_26/rtl
253 r_MiiMRst is not used for resetting the MIIM module. wb_rst used instead. mohor 7374d 12h /ethmac/tags/rel_26/rtl
251 When control frame (PAUSE) was sent, status was written in the
eth_wishbone module and both TXB and TXC interrupts were set. Fixed.
Only TXC interrupt is set.
mohor 7374d 12h /ethmac/tags/rel_26/rtl
250 AddressMiss status is connecting to the Rx BD. AddressMiss is identifying
that a frame was received because of the promiscous mode.
mohor 7374d 12h /ethmac/tags/rel_26/rtl

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2023, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.