OpenCores
URL https://opencores.org/ocsvn/ethmac/ethmac/trunk

Subversion Repositories ethmac

[/] [ethmac/] [trunk/] - Rev 268

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
268 Release 1.19. Control frame description changed. mohor 8048d 08h /ethmac/trunk/
267 Full duplex control frames tested. mohor 8048d 10h /ethmac/trunk/
266 Flow control test almost finished. mohor 8053d 09h /ethmac/trunk/
264 Registers RxStatusWrite_rck and RxStatusWriteLatched were not used
anywhere. Removed.
mohor 8053d 13h /ethmac/trunk/
263 test_mac_full_duplex_flow_control tests pretty much finished.
TEST 0: INSERT CONTROL FRM. WHILE TRANSMITTING NORMAL
FRM. AT 4 TX BD ( 10Mbps ) finished.
TEST 2: RECEIVE CONTROL FRAMES WITH PASSALL OPTION
TURNED OFF AT ONE RX BD ( 10Mbps ) finished.
mohor 8054d 00h /ethmac/trunk/
262 Version 1.18 released.
MIIMRST (Reset of the MIIM module) not used any more in the MIIMODER
register. Control Frame bit (CF) added to the RX buffer descriptor. Control
frame detection section updated.
mohor 8054d 01h /ethmac/trunk/
261 Rx Flow control fixed. CF flag added to the RX buffer descriptor. RxAbort
synchronized.
mohor 8054d 01h /ethmac/trunk/
260 test_mac_full_duplex_flow test 0 finished. Sending the control (PAUSE) frame
finished.
mohor 8054d 13h /ethmac/trunk/
259 In loopback rx_clk is not looped back. Possible CRC error. Consider if usage
of additional logic is necessery (FIFO for looping the data).
mohor 8055d 02h /ethmac/trunk/
257 When TxUsedData and CtrlMux occur at the same time, byte counter needs
to be incremented by 2. Signal IncrementByteCntBy2 added for that reason.
mohor 8055d 02h /ethmac/trunk/
256 TxDone and TxAbort changed so they're not propagated to the wishbone
module when control frame is transmitted.
mohor 8055d 02h /ethmac/trunk/
255 TPauseRq synchronized to tx_clk. mohor 8055d 03h /ethmac/trunk/
254 Temp version. mohor 8056d 06h /ethmac/trunk/
253 r_MiiMRst is not used for resetting the MIIM module. wb_rst used instead. mohor 8056d 08h /ethmac/trunk/
252 Just some updates. tadejm 8056d 09h /ethmac/trunk/
251 When control frame (PAUSE) was sent, status was written in the
eth_wishbone module and both TXB and TXC interrupts were set. Fixed.
Only TXC interrupt is set.
mohor 8056d 09h /ethmac/trunk/
250 AddressMiss status is connecting to the Rx BD. AddressMiss is identifying
that a frame was received because of the promiscous mode.
mohor 8056d 09h /ethmac/trunk/
248 wb_rst_i is used for MIIM reset. mohor 8057d 09h /ethmac/trunk/
246 Since r_Rst bit is not used any more, default value is changed to 0xa000. mohor 8060d 12h /ethmac/trunk/
245 Rev 1.7. mohor 8061d 06h /ethmac/trunk/

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.