OpenCores
URL https://opencores.org/ocsvn/ethmac/ethmac/trunk

Subversion Repositories ethmac

[/] [ethmac/] [trunk/] - Rev 275

Rev

Go to most recent revision | Details | Compare with Previous | Blame

Filtering Options

Clear current filter

Rev Log message Author Age Path
275 Fix MTxErr or prevent sending too big frames. mohor 7756d 06h /ethmac/trunk
274 Backup version. Not fully working. tadejm 7756d 19h /ethmac/trunk
272 When control packets were received, they were ignored in some cases. tadejm 7757d 01h /ethmac/trunk
270 When receiving normal data frame and RxFlow control was switched on, RXB
interrupt was not set.		 mohor 7758d 03h /ethmac/trunk
269 When in full duplex, transmit was sometimes blocked. Fixed. mohor 7759d 03h /ethmac/trunk
268 Release 1.19. Control frame description changed. mohor 7812d 20h /ethmac/trunk
267 Full duplex control frames tested. mohor 7812d 23h /ethmac/trunk
266 Flow control test almost finished. mohor 7817d 21h /ethmac/trunk
264 Registers RxStatusWrite_rck and RxStatusWriteLatched were not used
anywhere. Removed.		 mohor 7818d 02h /ethmac/trunk
263 test_mac_full_duplex_flow_control tests pretty much finished.
TEST 0: INSERT CONTROL FRM. WHILE TRANSMITTING NORMAL
FRM. AT 4 TX BD ( 10Mbps ) finished.
TEST 2: RECEIVE CONTROL FRAMES WITH PASSALL OPTION
TURNED OFF AT ONE RX BD ( 10Mbps ) finished.		 mohor 7818d 13h /ethmac/trunk
262 Version 1.18 released.
MIIMRST (Reset of the MIIM module) not used any more in the MIIMODER
register. Control Frame bit (CF) added to the RX buffer descriptor. Control
frame detection section updated.		 mohor 7818d 13h /ethmac/trunk
261 Rx Flow control fixed. CF flag added to the RX buffer descriptor. RxAbort
synchronized.		 mohor 7818d 13h /ethmac/trunk
260 test_mac_full_duplex_flow test 0 finished. Sending the control (PAUSE) frame
finished.		 mohor 7819d 01h /ethmac/trunk
259 In loopback rx_clk is not looped back. Possible CRC error. Consider if usage
of additional logic is necessery (FIFO for looping the data).		 mohor 7819d 14h /ethmac/trunk
257 When TxUsedData and CtrlMux occur at the same time, byte counter needs
to be incremented by 2. Signal IncrementByteCntBy2 added for that reason.		 mohor 7819d 15h /ethmac/trunk
256 TxDone and TxAbort changed so they're not propagated to the wishbone
module when control frame is transmitted.		 mohor 7819d 15h /ethmac/trunk
255 TPauseRq synchronized to tx_clk. mohor 7819d 15h /ethmac/trunk
254 Temp version. mohor 7820d 19h /ethmac/trunk
253 r_MiiMRst is not used for resetting the MIIM module. wb_rst used instead. mohor 7820d 21h /ethmac/trunk
252 Just some updates. tadejm 7820d 21h /ethmac/trunk

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.