Subversion Repositories ethmac

[/] [ethmac/] [trunk/] - Rev 275


Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
275 Fix MTxErr or prevent sending too big frames. mohor 7361d 06h /ethmac/trunk/
274 Backup version. Not fully working. tadejm 7361d 19h /ethmac/trunk/
272 When control packets were received, they were ignored in some cases. tadejm 7362d 01h /ethmac/trunk/
270 When receiving normal data frame and RxFlow control was switched on, RXB
interrupt was not set.
mohor 7363d 03h /ethmac/trunk/
269 When in full duplex, transmit was sometimes blocked. Fixed. mohor 7364d 03h /ethmac/trunk/
268 Release 1.19. Control frame description changed. mohor 7417d 20h /ethmac/trunk/
267 Full duplex control frames tested. mohor 7417d 22h /ethmac/trunk/
266 Flow control test almost finished. mohor 7422d 21h /ethmac/trunk/
264 Registers RxStatusWrite_rck and RxStatusWriteLatched were not used
anywhere. Removed.
mohor 7423d 01h /ethmac/trunk/
263 test_mac_full_duplex_flow_control tests pretty much finished.
FRM. AT 4 TX BD ( 10Mbps ) finished.
TURNED OFF AT ONE RX BD ( 10Mbps ) finished.
mohor 7423d 13h /ethmac/trunk/
262 Version 1.18 released.
MIIMRST (Reset of the MIIM module) not used any more in the MIIMODER
register. Control Frame bit (CF) added to the RX buffer descriptor. Control
frame detection section updated.
mohor 7423d 13h /ethmac/trunk/
261 Rx Flow control fixed. CF flag added to the RX buffer descriptor. RxAbort
mohor 7423d 13h /ethmac/trunk/
260 test_mac_full_duplex_flow test 0 finished. Sending the control (PAUSE) frame
mohor 7424d 01h /ethmac/trunk/
259 In loopback rx_clk is not looped back. Possible CRC error. Consider if usage
of additional logic is necessery (FIFO for looping the data).
mohor 7424d 14h /ethmac/trunk/
257 When TxUsedData and CtrlMux occur at the same time, byte counter needs
to be incremented by 2. Signal IncrementByteCntBy2 added for that reason.
mohor 7424d 15h /ethmac/trunk/
256 TxDone and TxAbort changed so they're not propagated to the wishbone
module when control frame is transmitted.
mohor 7424d 15h /ethmac/trunk/
255 TPauseRq synchronized to tx_clk. mohor 7424d 15h /ethmac/trunk/
254 Temp version. mohor 7425d 18h /ethmac/trunk/
253 r_MiiMRst is not used for resetting the MIIM module. wb_rst used instead. mohor 7425d 21h /ethmac/trunk/
252 Just some updates. tadejm 7425d 21h /ethmac/trunk/
251 When control frame (PAUSE) was sent, status was written in the
eth_wishbone module and both TXB and TXC interrupts were set. Fixed.
Only TXC interrupt is set.
mohor 7425d 21h /ethmac/trunk/
250 AddressMiss status is connecting to the Rx BD. AddressMiss is identifying
that a frame was received because of the promiscous mode.
mohor 7425d 21h /ethmac/trunk/
248 wb_rst_i is used for MIIM reset. mohor 7426d 21h /ethmac/trunk/
246 Since r_Rst bit is not used any more, default value is changed to 0xa000. mohor 7430d 00h /ethmac/trunk/
245 Rev 1.7. mohor 7430d 18h /ethmac/trunk/
244 r_Rst signal does not reset any module any more and is removed from the design. mohor 7430d 20h /ethmac/trunk/
243 Late collision is not reported any more. tadejm 7431d 02h /ethmac/trunk/
242 Late collision is reported only when not in the full duplex.
Sample is taken (for status) as soon as MRxDV is not valid (regardless
of the received byte cnt).
tadejm 7431d 16h /ethmac/trunk/
241 StartIdle state changed (not important the size of the packet).
StartData1 activates only while ByteCnt is smaller than the MaxFrame.
tadejm 7431d 16h /ethmac/trunk/
240 All modules are reset with wb_rst instead of the r_Rst. Exception is MII module. tadejm 7431d 16h /ethmac/trunk/

powered by: WebSVN 2.1.0

© copyright 1999-2023, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.