OpenCores
URL https://opencores.org/ocsvn/ethmac/ethmac/trunk

Subversion Repositories ethmac

[/] [ethmac/] [trunk/] - Rev 281

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
281 Tests test_mac_full_duplex_receive 4-7 fixed to proper BD. mohor 8082d 00h /ethmac/trunk/
280 Reset has priority in some flipflops. mohor 8083d 02h /ethmac/trunk/
279 Underrun test fixed. Many other tests fixed. mohor 8083d 03h /ethmac/trunk/
278 A new bug (entered with previous update) fixed. When abort occured sometimes
data transmission was blocked.		 mohor 8083d 03h /ethmac/trunk/
277 When padding was enabled and crc disabled, frame was not ended correctly. mohor 8083d 03h /ethmac/trunk/
276 Defer indication changed. tadejm 8083d 03h /ethmac/trunk/
275 Fix MTxErr or prevent sending too big frames. mohor 8090d 07h /ethmac/trunk/
274 Backup version. Not fully working. tadejm 8090d 21h /ethmac/trunk/
272 When control packets were received, they were ignored in some cases. tadejm 8091d 03h /ethmac/trunk/
270 When receiving normal data frame and RxFlow control was switched on, RXB
interrupt was not set.		 mohor 8092d 04h /ethmac/trunk/
269 When in full duplex, transmit was sometimes blocked. Fixed. mohor 8093d 04h /ethmac/trunk/
268 Release 1.19. Control frame description changed. mohor 8146d 22h /ethmac/trunk/
267 Full duplex control frames tested. mohor 8147d 00h /ethmac/trunk/
266 Flow control test almost finished. mohor 8151d 23h /ethmac/trunk/
264 Registers RxStatusWrite_rck and RxStatusWriteLatched were not used
anywhere. Removed.		 mohor 8152d 03h /ethmac/trunk/
263 test_mac_full_duplex_flow_control tests pretty much finished.
TEST 0: INSERT CONTROL FRM. WHILE TRANSMITTING NORMAL
FRM. AT 4 TX BD ( 10Mbps ) finished.
TEST 2: RECEIVE CONTROL FRAMES WITH PASSALL OPTION
TURNED OFF AT ONE RX BD ( 10Mbps ) finished.		 mohor 8152d 14h /ethmac/trunk/
262 Version 1.18 released.
MIIMRST (Reset of the MIIM module) not used any more in the MIIMODER
register. Control Frame bit (CF) added to the RX buffer descriptor. Control
frame detection section updated.		 mohor 8152d 14h /ethmac/trunk/
261 Rx Flow control fixed. CF flag added to the RX buffer descriptor. RxAbort
synchronized.		 mohor 8152d 14h /ethmac/trunk/
260 test_mac_full_duplex_flow test 0 finished. Sending the control (PAUSE) frame
finished.		 mohor 8153d 02h /ethmac/trunk/
259 In loopback rx_clk is not looped back. Possible CRC error. Consider if usage
of additional logic is necessery (FIFO for looping the data).		 mohor 8153d 16h /ethmac/trunk/
257 When TxUsedData and CtrlMux occur at the same time, byte counter needs
to be incremented by 2. Signal IncrementByteCntBy2 added for that reason.		 mohor 8153d 16h /ethmac/trunk/
256 TxDone and TxAbort changed so they're not propagated to the wishbone
module when control frame is transmitted.		 mohor 8153d 16h /ethmac/trunk/
255 TPauseRq synchronized to tx_clk. mohor 8153d 16h /ethmac/trunk/
254 Temp version. mohor 8154d 20h /ethmac/trunk/
253 r_MiiMRst is not used for resetting the MIIM module. wb_rst used instead. mohor 8154d 22h /ethmac/trunk/
252 Just some updates. tadejm 8154d 23h /ethmac/trunk/
251 When control frame (PAUSE) was sent, status was written in the
eth_wishbone module and both TXB and TXC interrupts were set. Fixed.
Only TXC interrupt is set.		 mohor 8154d 23h /ethmac/trunk/
250 AddressMiss status is connecting to the Rx BD. AddressMiss is identifying
that a frame was received because of the promiscous mode.		 mohor 8154d 23h /ethmac/trunk/
248 wb_rst_i is used for MIIM reset. mohor 8155d 23h /ethmac/trunk/
246 Since r_Rst bit is not used any more, default value is changed to 0xa000. mohor 8159d 02h /ethmac/trunk/

powered by: WebSVN 2.1.0

© copyright 1999-2025 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.