Subversion Repositories ethmac

[/] - Rev 103


Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
103 Wishbone signals are registered when ETH_REGISTERED_OUTPUTS is
selected in eth_defines.v
mohor 7529d 04h /
102 Interrupts are visible in the ETH_INT_SOURCE regardless if they are enabled
or not.
mohor 7529d 04h /
101 Short frame and ReceivedLengthOK were not detected correctly. mohor 7529d 05h /
100 Generic ram or Xilinx ram can be used in fifo (selectable by setting
ETH_FIFO_XILINX in eth_defines.v).
mohor 7529d 05h /
99 Document revised. mohor 7536d 03h /
98 Document revised. mohor 7536d 04h /
97 Small typo fixed. lampret 7553d 02h /
96 Any address can be used for Tx and Rx BD pointers. Address does not need
to be aligned.
mohor 7557d 02h /
95 md_padoen_o changed to md_padoe_o. Signal was always active high, just
name was incorrect.
mohor 7557d 05h /
94 When clear and read/write are active at the same time, cnt and pointers are
set to 1.
mohor 7557d 05h /
93 When in promiscous mode some frames were not received correctly. Fixed. mohor 7562d 03h /
92 Some defines that are used in testbench only were moved to tb_eth_defines.v
mohor 7563d 06h /
91 Comments in Slovene language removed. mohor 7563d 06h /
90 casex changed with case, fifo reset changed. mohor 7563d 06h /
89 TX_BD_NUM, MAC_ADDR0 and MAC_ADDR1 register description
mohor 7567d 04h /
88 rx_fifo was not always cleared ok. Fixed. mohor 7573d 02h /
87 Status was not latched correctly sometimes. Fixed. mohor 7573d 05h /
86 Big Endian problem when sending frames fixed. mohor 7574d 12h /
85 Log info was missing. mohor 7579d 21h /
84 LinkFail signal was not latching appropriate bit. mohor 7579d 21h /
83 MAC address recognition was not correct (bytes swaped). mohor 7579d 21h /
82 Byte ordering changed (Big Endian used). casex changed with case because
Xilinx Foundation had problems. Tested in HW. It WORKS.
mohor 7579d 23h /
81 Typos fixed, INT_SOURCE and INT_MASK registers changed. mohor 7580d 00h /
80 Small fixes for external/internal DMA missmatches. mohor 7584d 01h /
79 RetryCntLatched was unused and removed from design mohor 7584d 02h /
78 WB_SEL_I was unused and removed from design mohor 7584d 02h /
77 Interrupts changed mohor 7584d 02h /
76 Interrupts changed in the top file mohor 7584d 02h /
75 r_Bro is used for accepting/denying frames mohor 7584d 02h /
74 Reset values are passed to registers through parameters mohor 7584d 02h /

powered by: WebSVN 2.1.0

© copyright 1999-2022, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.