OpenCores
URL https://opencores.org/ocsvn/minsoc/minsoc/trunk

Subversion Repositories minsoc

[/] - Rev 151

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
151 Creating tag release-1.0 from revision 150 of branches/rc-1.0. rfajardo 4504d 00h /
150 Updating installation script to retrieve minsoc from tags/release-1.0. rfajardo 4504d 00h /
149 Merging differences of release candidate 1.0 revision 140:148 with trunk. rfajardo 4504d 01h /
148 Renaming minsoc_wave.lxt to minsoc_wave.lxt2 for correctness. rfajardo 4508d 21h /
147 Updating minsoc_bench.v to correctly acquire uart data.

Uart drivers: when an end of line character was sent, the driver appended a carriage return to it. This is not necessary and has been removed.
-Eth and Uart firmwares also had a carriage return after the end of line, also removed.

Minsoc_bench_defines.v: Renaming VCD_OUTPUT define to WAVEFORM_OUTPUT

run_bench: selecting -lxt2 for waveform output format. This output format size is 10 times smaller than vcd.

minsoc-install.sh: lxt2 output format requires that Icarus Verilog be installed with zlib support. For that, we now check if zlib is supported on script run.
rfajardo 4508d 23h /
146 Importing 'Xilinx Microblaze Dev. Kit 1600E Edition' board configuration directory. ConX. 4509d 05h /
145 minsoc_bench_core.v and minsoc_bench_clock.v left only on verilator branche. It will develop there until it is ported for inclusion into trunk. RC-1.0 is now clean of it. rfajardo 4509d 14h /
144 Updating configure scripts. Calling make into the right directories now. rfajardo 4510d 00h /
143 Compiling firmwares in board configuration scripts instead of on global minsoc setup. rfajardo 4510d 00h /
142 Updating configure.sh:
1) we don't patch the trunk version.
2) it is better to re-compile the firmwares on reconfiguration. So compiling firmwares went to configure scripts instead.

backend/xxx/configure: compiling firmwares here now.
rfajardo 4510d 00h /
141 Merging with rc-1.0 revision 140. I doubt rc-1.0 will still change much in the last days. rfajardo 4510d 00h /
140 Including required modules for verilator simulation. rfajardo 4510d 01h /
139 Creating a verilator branche. rfajardo 4510d 01h /
138 DIR_TO_INSTALL creation using wizard ConX. 4510d 14h /
137 Removing uncomplete support for ml509 and not working support for spartan3e_starter_kit_eth (area constraint cannot be reached). rfajardo 4511d 00h /
136 Installation on Ubuntu-11.10 has shown that a binary called makeinfo is required to install GDB. This binary can be installed on Ubuntu by installing the package texinfo. rfajardo 4517d 20h /
135 Installation on Ubuntu-11.10 has shown that package texinfo is required to compiled GDB. This package installs the binary makeinfo. rfajardo 4517d 20h /
134 run_sim.bat for ModelSim updated to acquire the firmware_size for command line input when running the testbench. rfajardo 4525d 00h /
133 Roll back minsoc_bench.v to timed simulation. Merge minsoc_bench_core and minsoc_bench_clock again.

Applying Rubén Diez patch to avoid warnings on firmware load for simulation.
rfajardo 4525d 01h /
132 ModelSim simulation, running top_module minsoc_bench_clock now, instead of minsoc_bench. rfajardo 4528d 21h /

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.