OpenCores
URL https://opencores.org/ocsvn/minsoc/minsoc/trunk

Subversion Repositories minsoc

[/] [minsoc/] [trunk/] [utils/] [setup/] [configure.sh] - Rev 166

Rev

Go to most recent revision | Details | Compare with Previous | Blame

Filtering Options

Clear current filter

Rev Log message Author Age Path
158 Adding de2_115_board port, thanks to Richard Hasha.

Support to JSP (JTAG Serial Port) working well. Also provided by Richard Hasha.

Different interconnect configurations per board are not straightforward on MinSoC. New added modules or definitions for addresses have to be carried over to other boards. Furthermore, extra modules can be shared among all projects. Thus, it is better to have this centralized:
-Removing interconnect configuration from minsoc_defines.v. There is an interconnect_defines.v file on rtl/verilog. The software counterpart is interconnect.h on sw/drivers.

Including a jsp firmware. It is basically the uart firmware but using JSP instead. Added to all board configure scripts to be compiled on configuration.

prj/srcs extended to include jsp and interconnec_defines.v.

spartan3e_starter_kit_eth lost UART (does not fit) and uses JSP instead now.
rfajardo 4466d 05h /minsoc/trunk/utils/setup/configure.sh
142 Updating configure.sh:
1) we don't patch the trunk version.
2) it is better to re-compile the firmwares on reconfiguration. So compiling firmwares went to configure scripts instead.

backend/xxx/configure: compiling firmwares here now.
rfajardo 4510d 14h /minsoc/trunk/utils/setup/configure.sh
141 Merging with rc-1.0 revision 140. I doubt rc-1.0 will still change much in the last days. rfajardo 4510d 14h /minsoc/trunk/utils/setup/configure.sh
121 Asserting svn:executable properties of modelsim/*.bat scripts.

Including corrected patch for advanced debug system watchpoints under utils/setup. Configure script updated to use this instead of advanced debug system patches. This will remain so until the patch is corrected. The previous line still has the correct command.
rfajardo 4536d 05h /minsoc/branches/rc-1.0/utils/setup/configure.sh
115 configure.sh script dir aware.
minsoc-install.sh logging to script dir.
rfajardo 4536d 10h /minsoc/branches/rc-1.0/utils/setup/configure.sh
113 minsoc-install.sh & minsoc-configure.sh:
-aware of location of configure.sh script
configure.sh:
-does not block on patch error

spartan3e_starter_kit & spartan3e_starter_kit_eth:
-or1200_defines.v updated

prj:
-src/blackboxes/or1200_top.v adjusted to or1200_rel1
-Makefile had a typo regarding altera vhdl files
rfajardo 4536d 11h /minsoc/branches/rc-1.0/utils/setup/configure.sh
112 Updating installation & configuration scripts. rfajardo 4537d 02h /minsoc/branches/rc-1.0/utils/setup/configure.sh
110 Fixing several minor issues with the system:
-minsoc-install splitted into installation and configuration
-minsoc-configure.sh can be used to configure a fresh checked out system
-configure script used by both minsoc-configure.sh and minsoc-install.sh to configure

-rtl/verilog: svn externals fixed
-or1200 rolled back to release-1.0

-prj/scripts:
-Makefile has been used by simulation to differentiate project definition of vhdl and verilog files
-Altera was differentiating it in script
-now there are two scripts, one for vhdl and another for verilog. The differentiation occurs in Makefile as for simulation.
-altera_3c25_board/configure scripts had to be updated, vprj and vhdprj file extensions used to differentiate Verilog and VHDL project files.

-prj/src: or1200_top.prj downdated to definition of or1200_v1
rfajardo 4537d 03h /minsoc/branches/rc-1.0/utils/setup/configure.sh

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.