OpenCores
URL https://opencores.org/ocsvn/minsoc/minsoc/trunk

Subversion Repositories minsoc

[/] [minsoc/] [trunk] - Rev 166

Rev

Go to most recent revision | Details | Compare with Previous | Blame

Filtering Options

Clear current filter

Rev Log message Author Age Path
166 Turning on warnings for genera_bench.

Updating minsoc-install.sh to work better with directories and working around a missing inclusion of libftdi autotools. http://opencores.org/forum,OpenRISC,0,4685,1
rfajardo 4358d 14h /minsoc/trunk
165 Board contribution: nexys2_1200 (Thanks to Johan Granath)

spartan3e_starter_kit_eth/minsoc_bench_defines.v: deprecated definition updated
rfajardo 4375d 15h /minsoc/trunk
164 Updating width of minsoc_tc_top.v for Wishbone B3 compliance. This file has never worked. This solves at least the bug that some signals were not being routed through. rfajardo 4440d 07h /minsoc/trunk
163 Adjusting internal initiator array widths. They were 1 bit too large. Thanks to R. Diez report.

These arrays abstract the complete initiator inputs. This way it is easier to route and arbiter using a single input.

Also removing 2 sequential delays. I didn't design them, so I can't tell if they were really useful/good.
rfajardo 4446d 14h /minsoc/trunk
162 Tasks don't have parenthesis. This is only used for ports on modules. This was a mistake from my part. rfajardo 4452d 09h /minsoc/trunk
161 Correcting configure parameters of adv_jtag_bridge on installation script. rfajardo 4465d 12h /minsoc/trunk
160 Typo in minsoc-install.sh script. Adv_jtag_bridge was not configuring correctly. rfajardo 4465d 12h /minsoc/trunk
159 Updated constraint file for de2_115 board. (Richard Hasha) rfajardo 4465d 13h /minsoc/trunk
158 Adding de2_115_board port, thanks to Richard Hasha.

Support to JSP (JTAG Serial Port) working well. Also provided by Richard Hasha.

Different interconnect configurations per board are not straightforward on MinSoC. New added modules or definitions for addresses have to be carried over to other boards. Furthermore, extra modules can be shared among all projects. Thus, it is better to have this centralized:
-Removing interconnect configuration from minsoc_defines.v. There is an interconnect_defines.v file on rtl/verilog. The software counterpart is interconnect.h on sw/drivers.

Including a jsp firmware. It is basically the uart firmware but using JSP instead. Added to all board configure scripts to be compiled on configuration.

prj/srcs extended to include jsp and interconnec_defines.v.

spartan3e_starter_kit_eth lost UART (does not fit) and uses JSP instead now.
rfajardo 4467d 05h /minsoc/trunk
157 Removed obsolete file; the changes in this version have been merged into
the mainline advanced debug system version 3.0 and higher.
nyawn 4473d 00h /minsoc/trunk
156 Added hardware watchpoint indicators to debug unit break input, to allow
the debugger to break when a hardware watchpoint is triggered.
nyawn 4473d 00h /minsoc/trunk
155 Decreased wait time, for faster simulations. nyawn 4473d 00h /minsoc/trunk
154 Modified to use the new autotools support in the advanced debug system v3.0. nyawn 4473d 00h /minsoc/trunk
149 Merging differences of release candidate 1.0 revision 140:148 with trunk. rfajardo 4505d 14h /minsoc/trunk
144 Updating configure scripts. Calling make into the right directories now. rfajardo 4511d 13h /minsoc/trunk
142 Updating configure.sh:
1) we don't patch the trunk version.
2) it is better to re-compile the firmwares on reconfiguration. So compiling firmwares went to configure scripts instead.

backend/xxx/configure: compiling firmwares here now.
rfajardo 4511d 13h /minsoc/trunk
141 Merging with rc-1.0 revision 140. I doubt rc-1.0 will still change much in the last days. rfajardo 4511d 13h /minsoc/trunk
135 Installation on Ubuntu-11.10 has shown that package texinfo is required to compiled GDB. This package installs the binary makeinfo. rfajardo 4519d 09h /minsoc/trunk
108 Scripts updates to correct paths when working under Windows. Now, ModelSim, Xilinx and Altera synthesis are working on Windows through batch files.

Icarus Verilog and Altera synthesis are working as well. Job done!
rfajardo 4538d 07h /minsoc/trunk
107 Adding setup batch script for Altera synthesis on Windows.

prj/scripts/altprj.sh has now to check if it is run from cygwin in order to re-formulate the path to windows system.

Maybe the other scripts have to be updated too. This will be checked soon.
rfajardo 4538d 10h /minsoc/trunk

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.