Plasma - most MIPS I(TM) opcodes

The idea of ddr test is 'make ddr_test' and 'make toimage'. Then, program FPGA with .bit and connect to serial port. Finally, send test.bin and i should be the test right?. The thing is that it doesn't works. Please can anybody help me?. Thanks.

You dont mention which board you are using. However before running DDR test load up the boot loader and use the read / write / dump memory functions to see if you can read and write to memory. From memory ( no pun intended :-) ) I seem to remember ( again ...sigh ) that I found that there was an issue with the decoding for the DDR and the test did not appear to run. If you are running the Spartan 3E starter kit ..press the rotary knob to soft reset the Plasma. Regards.

Does bootldr work? Can you run the count test program? Which FPGA and board are you using?