Subversion Repositories cic

### This file controls the configuration of the svnserve daemon, if you

### use it to allow access to this repository.  (If you only allow

### access through http: and/or file: URLs, then this file is

### irrelevant.)

### Visit http://subversion.apache.org/ for more information.

[general]

### The anon-access and auth-access options control access to the

### repository for unauthenticated (a.k.a. anonymous) users and

### authenticated users, respectively.

### Valid values are "write", "read", and "none".

### Setting the value to "none" prohibits both reading and writing;

### "read" allows read-only access, and "write" allows complete

### read/write access to the repository.

### The sample settings below are the defaults and specify that anonymous

### users have read-only access to the repository, while authenticated

### users have read and write access to the repository.

# anon-access = read

# auth-access = write

### The password-db option controls the location of the password

### database file.  Unless you specify a path starting with a /,

### the file's location is relative to the directory containing

### this configuration file.

### If SASL is enabled (see below), this file will NOT be used.

### Uncomment the line below to use the default password file.

# password-db = passwd

### The authz-db option controls the location of the authorization

### rules for path-based access control.  Unless you specify a path

### starting with a /, the file's location is relative to the the

### directory containing this file.  If you don't specify an

### authz-db, no path-based access control is done.

### Uncomment the line below to use the default authorization file.

# authz-db = authz

### This option specifies the authentication realm of the repository.

### If two repositories have the same authentication realm, they should

### have the same password database, and vice versa.  The default realm

### is repository's uuid.

# realm = My First Repository

### The force-username-case option causes svnserve to case-normalize

### usernames before comparing them against the authorization rules in the

### authz-db file configured above.  Valid values are "upper" (to upper-

### case the usernames), "lower" (to lowercase the usernames), and

### "none" (to compare usernames as-is without case conversion, which

### is the default behavior).

# force-username-case = none

[sasl]

### This option specifies whether you want to use the Cyrus SASL

### library for authentication. Default is false.

### This section will be ignored if svnserve is not built with Cyrus

### SASL support; to check, run 'svnserve --version' and look for a line

### reading 'Cyrus SASL authentication is available.'

# use-sasl = true

### These options specify the desired strength of the security layer

### that you want SASL to provide. 0 means no encryption, 1 means

### integrity-checking only, values larger than 1 are correlated

### to the effective key length for encryption (e.g. 128 means 128-bit

### encryption). The values below are the defaults.

# min-encryption = 0

# max-encryption = 256