OpenCores
URL https://opencores.org/ocsvn/de1_olpcl2294_system/de1_olpcl2294_system/trunk

Subversion Repositories de1_olpcl2294_system

[/] [de1_olpcl2294_system/] [trunk/] [sw/] [ecos/] [openocd/] [lpc2294.cfg] - Rev 7

Go to most recent revision | Compare with Previous | Blame | View Log


#daemon configuration
telnet_port 4444
gdb_port 3333


#interface
interface ft2232
ft2232_device_desc "Olimex OpenOCD JTAG A"
ft2232_layout "olimex-jtag"
ft2232_vid_pid 0x15BA 0x0003
jtag_khz 1000

if { [info exists CHIPNAME] } { 
   set  _CHIPNAME $CHIPNAME    
} else {         
   set  _CHIPNAME lpc2294
}

if { [info exists ENDIAN] } {   
   set  _ENDIAN $ENDIAN    
} else {         
   set  _ENDIAN little
}

if { [info exists CPUTAPID ] } {
   set _CPUTAPID $CPUTAPID
} else {
  # force an error till we get a good number
   set _CPUTAPID 0xffffffff
}


#use combined on interfaces or targets that can't set TRST/SRST separately
jtag_nsrst_delay 25
jtag_ntrst_delay 25

reset_config trst_and_srst separate
# reset_config trst_only


#jtag scan chain
# jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id 0x4f1f0f0f

set _TARGETNAME [format "%s.cpu" $_CHIPNAME]
target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi-s_r4
$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x40000000 -work-area-size 0x4000 -work-area-backup 0

#flash configuration
#flash bank lpc2000 <base> <size> 0 0 <target#> <variant>
flash bank lpc2000 0x0 0x40000 0 0 0 lpc2000_v1 14765 calc_checksum

# flash bank cfi 0x81000000 0x100000 2 2 0


# For more information about the configuration files, take a look at:
# openocd.texi

Go to most recent revision | Compare with Previous | Blame | View Log

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.