OpenCores
URL https://opencores.org/ocsvn/uart16550/uart16550/trunk

Subversion Repositories uart16550

[/] [uart16550/] [trunk/] [rtl/] [verilog/] [uart_regs.v] - Rev 106

Rev

Details | Compare with Previous | Blame

Filtering Options

Clear current filter

Rev Log message Author Age Path
106 New directory structure. root 5569d 23h /uart16550/trunk/rtl/verilog/uart_regs.v
105 Timeout interrupt should be generated only when there is at least ony
character in the fifo.		 igorm 7139d 00h /uart16550/trunk/rtl/verilog/uart_regs.v
99 Added synchronizer flops for RX input. tadejm 7323d 21h /uart16550/trunk/rtl/verilog/uart_regs.v
87 This fixes errors in some cases when data is being read and put to the FIFO at the same time. Patch is submitted by Scott Furman. Update is very recommended. gorban 7668d 16h /uart16550/trunk/rtl/verilog/uart_regs.v
84 The uart_defines.v file is included again in sources. gorban 7985d 12h /uart16550/trunk/rtl/verilog/uart_regs.v
79 Bug Fixes:
* Possible loss of sync and bad reception of stop bit on slow baud rates fixed.
Problem reported by Kenny.Tung.
* Bad (or lack of ) loopback handling fixed. Reported by Cherry Withers.

Improvements:
* Made FIFO's as general inferrable memory where possible.
So on FPGA they should be inferred as RAM (Distributed RAM on Xilinx).
This saves about 1/3 of the Slice count and reduces P&R and synthesis times.

* Added optional baudrate output (baud_o).
This is identical to BAUDOUT* signal on 16550 chip.
It outputs 16xbit_clock_rate - the divided clock.
It's disabled by default. Define UART_HAS_BAUDRATE_OUTPUT to use.		 gorban 7992d 10h /uart16550/trunk/rtl/verilog/uart_regs.v
68 lsr[7] was not showing overrun errors. mohor 8199d 20h /uart16550/trunk/rtl/verilog/uart_regs.v
66 rx push changed to be only one cycle wide. mohor 8206d 20h /uart16550/trunk/rtl/verilog/uart_regs.v
64 Warnings cleared. mohor 8208d 01h /uart16550/trunk/rtl/verilog/uart_regs.v
63 Synplicity was having troubles with the comment. mohor 8208d 01h /uart16550/trunk/rtl/verilog/uart_regs.v
60 Things related to msr register changed. After THRE IRQ occurs, and one
character is written to the transmit fifo, the detection of the THRE bit in the
LSR is delayed for one character time.		 mohor 8209d 23h /uart16550/trunk/rtl/verilog/uart_regs.v
59 MSR register fixed. mohor 8212d 20h /uart16550/trunk/rtl/verilog/uart_regs.v
58 After reset modem status register MSR should be reset. mohor 8212d 23h /uart16550/trunk/rtl/verilog/uart_regs.v
56 thre irq should be cleared only when being source of interrupt. mohor 8213d 23h /uart16550/trunk/rtl/verilog/uart_regs.v
54 LSR status bit 0 was not cleared correctly in case of reseting the FCR (rx fifo). mohor 8215d 00h /uart16550/trunk/rtl/verilog/uart_regs.v
52 Scratch register added gorban 8216d 13h /uart16550/trunk/rtl/verilog/uart_regs.v
50 Bug in LSR[0] is fixed.
All WISHBONE signals are now sampled, so another wait-state is introduced on all transfers.		 gorban 8220d 18h /uart16550/trunk/rtl/verilog/uart_regs.v
48 Updated specification documentation.
Added full 32-bit data bus interface, now as default.
Address is 5-bit wide in 32-bit data bus mode.
Added wb_sel_i input to the core. It's used in the 32-bit mode.
Added debug interface with two 32-bit read-only registers in 32-bit mode.
Bits 5 and 6 of LSR are now only cleared on TX FIFO write.
My small test bench is modified to work with 32-bit mode.		 gorban 8223d 11h /uart16550/trunk/rtl/verilog/uart_regs.v
47 Fixed: timeout and break didn't pay attention to current data format when counting time gorban 8228d 13h /uart16550/trunk/rtl/verilog/uart_regs.v
45 Lots of fixes:
Break condition wasn't handled correctly at all.
LSR bits could lose their values.
LSR value after reset was wrong.
Timing of THRE interrupt signal corrected.
LSR bit 0 timing corrected.		 gorban 8230d 11h /uart16550/trunk/rtl/verilog/uart_regs.v

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.