OpenCores
URL https://opencores.org/ocsvn/amber/amber/trunk

Subversion Repositories amber

[/] - Rev 61

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
61 Add new netowkr based boot loader.
Remove support for Virtex. Spartan 6 only now.		 csantifort 4348d 10h /
60 Bug fix; removed a combinational loop from the a25_decode logic. csantifort 4566d 06h /
59 Added modelsim script for reloading a wlf file after a simulation has been rerun. csantifort 4636d 04h /
58 Use TB.clk_count for the decompiler messages and removed the local counter csantifort 4636d 07h /
57 Add some debug messages csantifort 4636d 07h /
56 Remove the timeouts file from svn. Its an output file and gets now just gets created automatically
when sims are run for the first time.		 csantifort 4636d 07h /
55 Added sudo to rm mnt command csantifort 4636d 07h /
54 Bug fix for bug reported by Botao Lee. The mode bits in the decode stage did not change immediately
after a mode switch from a teqp instruction, but 1 cycle later. This meant the wrong set of registers
was selected for writing to for 1 clock cycle.		 csantifort 4653d 07h /
53 Cleaned up Amber Verilog, removing unused signals. csantifort 4668d 05h /
52 Fixed typo in notes on creating DDR memory interfaces using coregen csantifort 4668d 05h /
51 Revert vmlinux back to 48. csantifort 4709d 05h /
50 Revert to previous version csantifort 4709d 05h /
49 Added a note n how to change timeouts csantifort 4709d 05h /
48 Fixed a bug in linux that caused the os to not return to the running application after an interrupt.
Hello-world now runs stand-alone again.
Added initrd-200k-dhry, a disk image that uses the dhry program for init.		 csantifort 4713d 11h /
47 Changed V6 VCo from 1000Mhz to 1200 MHz csantifort 4733d 09h /
46 svn ignore vmlinux.dis and vmlinux.mem csantifort 4741d 06h /
45 Store vmlinux.mem and vmlinux.dis in compressed form csantifort 4741d 06h /
44 Updated vmlinux image based on last change csantifort 4741d 07h /
43 Added support for the flat executable file format to vmlinux, so that the hello-world program is correctly relocated when it is loaded at the end of the vmlinux test.
Changed the Virtex-5 clock configuration to use a 1200MHz VCO frequency and 80MHz system clock frequency.		 csantifort 4741d 07h /
42 Added write buffer - fixes bug if wishbone writes takes multiple cycles to complete csantifort 4759d 03h /

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.