Hello,
Some colleagues and I are working to implement Igor Mohor's Controller Area Network (CAN) protocol controller onto a Xilinx Zynq-7000 SoC development board made by Digilent called the 'Zybo.' We plan on using Dan Stother's AXI-to-Wishbone bridge to link the ARM and FPGA.

Has anyone successfully used Igor's design or Dan's bridge?

I'll post updates here as we make progress.

Hi Brent,

I used the Igor's CAN design on an Altera Cyclone II. Access to the CAN Controller from a PCI Bus with WB I/F.
The design was not thoroughly tested, only at laboratory level. Anyway, It works well.

Reagrds.

Peio