OpenCores
Username:
Password:

Remember me
Register

Browse

GECKO4 SoC co-design environment

Issue List
Programming GECKO4Main FPGA via usbtmc fails #1
Closed ktt1 opened this issue over 13 years ago
ktt1 commented over 13 years ago

The command to program the GECKO4Main userFPGA directly via USB is "FPGA_<bitfile>". This command fails, if an inconsistent bitfile is located in the GECKO4com non-volatile

memory during power-on.

At the moment, this problem can be solved as follows:

  1. Erase the GECKO4com non-volatile memory using the "ERASE" command

  2. Power off the GECKO4 Module

  3. Power on the GECKO4 Module

  4. Run the "FPGA_<bitfile>" command

ktt1 closed this over 13 years ago
Assignee
No one
Labels
Bug
© copyright 1999-2018 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.