Subversion Repositories dblclockfft

# A Double-Clocked FFT Core Generator

The Double Clocked FFT project contains all of the software necessary to

create the IP to generate an arbitrary sized FFT that will clock two samples

in at each clock cycle, and after some pipeline delay it will clock two

samples out at every clock cycle.

The FFT generated by this approach is very configurable.  By simple adjustment

of a command line parameter, the FFT may be made to be a forward FFT or an

inverse FFT.  The number of bits processed, kept, and maintained by this

FFT are also configurable.  Even the number of bits used for the twiddle

factors, or whether or not to bit reverse the outputs, are all configurable

parts to this FFT core.

These features make the Double Clocked FFT very different and unique among the

other open HDL cores you may fine.

For those who wish to get started right away, please download the package,

change into the ``sw`` directory and run ``make``.  There is no need to

run a configure script, ``fftgen`` is completely portable C++.  Then, once

built, go ahead and run ``fftgen`` without any arguments.  This will cause

``fftgen`` to print a usage statement to the screen.  Review the usage

statement, and run ``fftgen`` a second time with the arguments you need.

Alternatively, you _could_ read the specification.

## Genesis

This FFT comes from my attempts to design and implement a signal processing

algorithm inside a generic FPGA, but only on a limited budget.  As such,

I don't yet have the FPGA board I wish to place this algorithm onto, neither

do I have any expensive modeling or simulation capabilities.  I'm using

Verilator for my modeling and simulation needs.  This makes

using a vendor supplied IP core, such as an FFT, difficult if not impossible

to use.

My problem was made worse when I learned that the published maximum clock

speed for a device wasn't necessarily the maximum clock speed that I could

achieve.  My design needed to process the incoming signal at 500 MHz to be

commercially viable.  500 MHz is not necessarily a clock speed

that can be easily achieved.  250 MHz, on the other hand, is much more within

the realm of possibility.  Achieving a 500 MHz performance with a 250 MHz

clock, however, requires an FFT that accepts two samples per clock.

This, then, was and is the genesis of this project.

# Commercial Applications

Should you find the GPLv3 license insufficient for your needs, other licenses

can be purchased from Gisselquist Technology, LLC.

Likewise, please contact us should you wish to fund the further development

of this core.