Subversion Repositories openmsp430

#-----------------------------------------------------------------------------#

# Sets the operating mode for Boundary-Scan (JTAG).                           #

#-----------------------------------------------------------------------------#

setMode -bscan

#-----------------------------------------------------------------------------#

# Tells iMPACT to automatically detect the cable. A Xilinx programming cable  #

# must be connected to your computer.                                         #

#-----------------------------------------------------------------------------#

setCable -port auto

#-----------------------------------------------------------------------------#

# Identifies the devices in the Boundary-Scan chain and adds each device to   #

# the list of devices to be configured. Applicable in Boundary-Scan           #

# configuration mode.                                                         #

#-----------------------------------------------------------------------------#

Identify -inferir

identifyMPM

#-----------------------------------------------------------------------------#

# Assigns a new configuration file to an existing device.                     #

#  -p          - Specifies the position of the device in the chain.      #

#  -file  - Specifies the name of the configuration file.           #

#-----------------------------------------------------------------------------#

assignFile -p 1 -file "./PROM_NAME.bit"

#-----------------------------------------------------------------------------#

# Indirect programming command which attaches an SPI Flash or BPI Flash       #

# device to an existing FPGA. The Flash device will be programmed through the #

# FPGA. Applicable in Boundary Scan mode.                                     #

# -p            - Specifies the position of the FPGA device in the chain.#

# -spi  - Specifies the SPI Flash device to attach to the FPGA.  #

# -bpi  - Specifies the BPI Flash device to attach to the FPGA.  #

#-----------------------------------------------------------------------------#

attachflash -position 1 -spi "N25Q128"

#-----------------------------------------------------------------------------#

# Indirect programming command which assigns a new configuration file to an   #

# existing BPI or SPI Flash device attached to an FPGA. The Flash device will #

# be programmed through the FPGA. Applicable in Boundary Scan mode.           #

# -p          - Specifies the position of the FPGA device in the chain.  #

# -file  - Specifies the name of the configuration file.            #

#-----------------------------------------------------------------------------#

assignfiletoattachedflash -p 1 -file "./PROM_NAME.mcs"

#-----------------------------------------------------------------------------#

# Programs a device with options to erase first, then verify after            #

# programming. Applicable to all configuration modes.                         #

# -p   - Refers to the position of the device(s) in the chain.           #

# -e        - Erases the device before programming.                           #

# -v        - Verifies the device has been programmed.                        #

# -w        - Write protects the device.                                      #

# -loadfpga - Sends JTAG instruction to the PROM which causes it to           #

#             automatically load the FPGA after PROM programming is complete. #

#-----------------------------------------------------------------------------#

Program -p 1 -dataWidth 1 -spionly -e -v -loadfpga

#-----------------------------------------------------------------------------#

# Exits iMPACT                                                                #

#-----------------------------------------------------------------------------#

quit