| 1 |
786 |
skrzyp |
<html>
|
| 2 |
|
|
<body>
|
| 3 |
|
|
<pre>
|
| 4 |
|
|
NAME
|
| 5 |
|
|
socket - create an endpoint for communication
|
| 6 |
|
|
|
| 7 |
|
|
SYNOPSIS
|
| 8 |
|
|
#include <network.h>
|
| 9 |
|
|
|
| 10 |
|
|
int socket(int domain, int type, int protocol);
|
| 11 |
|
|
|
| 12 |
|
|
DESCRIPTION
|
| 13 |
|
|
Socket creates an endpoint for communication and returns a
|
| 14 |
|
|
descriptor.
|
| 15 |
|
|
|
| 16 |
|
|
The domain parameter specifies a communications domain
|
| 17 |
|
|
within which communication will take place; this selects
|
| 18 |
|
|
the protocol family which should be used. These families
|
| 19 |
|
|
are defined in <network.h>. The currently understood
|
| 20 |
|
|
formats include:
|
| 21 |
|
|
|
| 22 |
|
|
PF_INET
|
| 23 |
|
|
IPv4 Internet protocols; see ip(4)
|
| 24 |
|
|
|
| 25 |
|
|
The socket has the indicated type, which specifies the
|
| 26 |
|
|
semantics of communication. Currently defined types are:
|
| 27 |
|
|
|
| 28 |
|
|
SOCK_STREAM
|
| 29 |
|
|
Provides sequenced, reliable, two-way connection-
|
| 30 |
|
|
based byte streams. An out-of-band data transmis-
|
| 31 |
|
|
sion mechanism may be supported.
|
| 32 |
|
|
|
| 33 |
|
|
SOCK_DGRAM
|
| 34 |
|
|
Supports datagrams (connectionless, unreliable mes-
|
| 35 |
|
|
sages of a fixed maximum length).
|
| 36 |
|
|
|
| 37 |
|
|
SOCK_SEQPACKET
|
| 38 |
|
|
Provides a sequenced, reliable, two-way connection-
|
| 39 |
|
|
based data transmission path for datagrams of fixed
|
| 40 |
|
|
maximum length; a consumer is required to read an
|
| 41 |
|
|
entire packet with each read system call.
|
| 42 |
|
|
|
| 43 |
|
|
SOCK_RAW
|
| 44 |
|
|
Provides raw network protocol access.
|
| 45 |
|
|
|
| 46 |
|
|
The protocol specifies a particular protocol to be used
|
| 47 |
|
|
with the socket. Normally only a single protocol exists
|
| 48 |
|
|
to support a particular socket type within a given proto-
|
| 49 |
|
|
col family. However, it is possible that many protocols
|
| 50 |
|
|
may exist, in which case a particular protocol must be
|
| 51 |
|
|
specified in this manner. The protocol number to use is
|
| 52 |
|
|
particular to the "communication domain" in which communi-
|
| 53 |
|
|
cation is to take place; see protocols(5). See getpro-
|
| 54 |
|
|
toent(3) on how to map protocol name strings to protocol
|
| 55 |
|
|
numbers.
|
| 56 |
|
|
|
| 57 |
|
|
Sockets of type SOCK_STREAM are full-duplex byte streams,
|
| 58 |
|
|
similar to pipes. A stream socket must be in a connected
|
| 59 |
|
|
state before any data may be sent or received on it. A
|
| 60 |
|
|
connection to another socket is created with a connect(2)
|
| 61 |
|
|
call. Once connected, data may be transferred using
|
| 62 |
|
|
read(2) and write(2) calls or some variant of the send(2)
|
| 63 |
|
|
and recv(2) calls. When a session has been completed a
|
| 64 |
|
|
close(2) may be performed. Out-of-band data may also be
|
| 65 |
|
|
transmitted as described in send(2) and received as
|
| 66 |
|
|
described in recv(2).
|
| 67 |
|
|
|
| 68 |
|
|
The communications protocols which implement a SOCK_STREAM
|
| 69 |
|
|
ensure that data is not lost or duplicated. If a piece of
|
| 70 |
|
|
data for which the peer protocol has buffer space cannot
|
| 71 |
|
|
be successfully transmitted within a reasonable length of
|
| 72 |
|
|
time, then the connection is considered When SO_KEEPALIVE
|
| 73 |
|
|
is enabled on the socket the protocol checks in a proto-
|
| 74 |
|
|
col-specific manner if the other end is still alive.
|
| 75 |
|
|
|
| 76 |
|
|
SOCK_DGRAM and SOCK_RAW sockets allow sending of datagrams
|
| 77 |
|
|
to correspondents named in send(2) calls. Datagrams are
|
| 78 |
|
|
generally received with recvfrom(2), which returns the
|
| 79 |
|
|
next datagram with its return address.
|
| 80 |
|
|
|
| 81 |
|
|
When the network signals an error condition to the proto-
|
| 82 |
|
|
col module (e.g. using a ICMP message for IP) the pending
|
| 83 |
|
|
error flag is set for the socket. The next operation on
|
| 84 |
|
|
this socket will return the error code of the pending
|
| 85 |
|
|
error. For some protocols it is possible to enable a per-
|
| 86 |
|
|
socket error queue to retrieve detailed information about
|
| 87 |
|
|
the error; see IP_RECVERR in ip(4).
|
| 88 |
|
|
|
| 89 |
|
|
The operation of sockets is controlled by socket level
|
| 90 |
|
|
options. These options are defined in <sys/socket.h>.
|
| 91 |
|
|
Setsockopt(2) and getsockopt(2) are used to set and get
|
| 92 |
|
|
options, respectively.
|
| 93 |
|
|
|
| 94 |
|
|
RETURN VALUES
|
| 95 |
|
|
-1 is returned if an error occurs; otherwise the return
|
| 96 |
|
|
value is a descriptor referencing the socket.
|
| 97 |
|
|
|
| 98 |
|
|
ERRORS
|
| 99 |
|
|
EPROTONOSUPPORT
|
| 100 |
|
|
The protocol type or the specified protocol is not
|
| 101 |
|
|
supported within this domain.
|
| 102 |
|
|
|
| 103 |
|
|
EMFILE There are too many open files.
|
| 104 |
|
|
|
| 105 |
|
|
EACCES Permission to create a socket of the specified
|
| 106 |
|
|
type and/or protocol is denied.
|
| 107 |
|
|
|
| 108 |
|
|
ENOBUFS or ENOMEM
|
| 109 |
|
|
Insufficient memory is available. The socket can-
|
| 110 |
|
|
not be created until sufficient resources are
|
| 111 |
|
|
freed.
|
| 112 |
|
|
|
| 113 |
|
|
EINVAL Unknown protocol, or protocol family not avail-
|
| 114 |
|
|
able.
|
| 115 |
|
|
</pre>
|
| 116 |
|
|
</body>
|
| 117 |
|
|
</html>
|
