Subversion Repositories openrisc

=============================================================================

List of methods in project: RTOSDemo

THIS TEXT DESCRIPTION IS GENERATED BY THE TOOL. DO NOT MODIFY IT.

=============================================================================

Module "TickTimer" (bean TimerInt)

   TickTimer_Enable -Enable the bean - it starts the timer. Events may be generated ("DisableEvent"/"EnableEvent").

   TickTimer_SetPeriodTicks16 -This method sets the new period of the generated events. The period is expressed in CPU [ticks]

                as a 16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is

                selected in the  in Runtime setting area.

   TickTimer_SetPeriodTicks32 -This method sets the new period of the generated events. The period is expressed in CPU [ticks]

                as a 32-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is

                selected in the  in Runtime setting area.

   TickTimer_SetPeriodUS -This method sets the new period of the generated events. The period is expressed in [microseconds] as

                a 16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is

                selected in the  in Runtime setting area.

   TickTimer_SetPeriodMS -This method sets the new period of the generated events. The period is expressed in [miliseconds] as

                a 16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is

                selected in the  in Runtime setting area.

   TickTimer_SetFreqHz -This method sets the new frequency of the generated events. The frequency is expressed in [Hz] as a

                16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is

                selected in the  in Runtime setting area.

Module "Byte1"     (bean ByteIO)

   Byte1_PutBit -Put the specified value to the specified bit/pin of the Input/Output bean. If direction is [input] saves the

                value to a memory or a register, this value will be written to the pin after switching to the output mode -

                using [SetDir(TRUE)]. If direction is [output] writes the value to the pin.

   Byte1_NegBit -Negate (invert) the specified bit of the Input/Output bean. It is the same as [PutBit(Bit,!GetBit(Bit))].

Module "COM0"      (bean AsynchroSerial)

   COM0_SetBaudRateMode -This method changes the channel communication speed (baud rate). This method can be used only if you

                specify a list of possible period settings at design time (see  - Runtime setting - from a

                list of values). Each of these settings constitutes a mode and Processor Expert^[TM] assigns them a mode

                identifier. The prescaler and compare values corresponding to each mode are calculated at design time. You may

                switch modes at runtime by referring only to a mode identifier. No run-time calculations are performed, all the

                calculations are performed at design time.

Module "Cpu"       (bean MC9S12DP256_112)

   Cpu_EnableInt -Enable maskable interrupts

   Cpu_DisableInt -Disable maskable interrupts

=============================================================================