Subversion Repositories or1200_soc

// --------------------------------------------------------------------

//

// --------------------------------------------------------------------

`include "timescale.v"

`include "soc_defines.v"

module top(

  ////////////////////////  Clock Input     ////////////////////////

  input [1:0]       clock_24,               //  24 MHz

  input [1:0]       clock_27,               //  27 MHz

  input             clock_50,               //  50 MHz

  input             ext_clock,              //  External Clock

  ////////////////////////  Push Button     ////////////////////////

  input [3:0]       key,                    //  Pushbutton[3:0]

  ////////////////////////  DPDT Switch     ////////////////////////

  input [9:0]       sw,                     //  Toggle Switch[9:0]

  ////////////////////////  7-SEG Dispaly   ////////////////////////

  output    [6:0]   hex0,                   //  Seven Segment Digit 0

  output    [6:0]   hex1,                   //  Seven Segment Digit 1

  output    [6:0]   hex2,                   //  Seven Segment Digit 2

  output    [6:0]   hex3,                   //  Seven Segment Digit 3

  ////////////////////////////  LED     ////////////////////////////

  output    [7:0]   ledg,                   //  LED Green[7:0]

  output    [9:0]   ledr,                   //  LED Red[9:0]

  ////////////////////////////  UART    ////////////////////////////

  output            uart_txd,               //  UART Transmitter

  input             uart_rxd,               //  UART Receiver

  ///////////////////////       SDRAM Interface ////////////////////////

  inout [15:0]      dram_dq,                //  SDRAM Data bus 16 Bits

  output    [11:0]  dram_addr,              //  SDRAM Address bus 12 Bits

  output            dram_ldqm,              //  SDRAM Low-byte Data Mask 

  output            dram_udqm,              //  SDRAM High-byte Data Mask

  output            dram_we_n,              //  SDRAM Write Enable

  output            dram_cas_n,             //  SDRAM Column Address Strobe

  output            dram_ras_n,             //  SDRAM Row Address Strobe

  output            dram_cs_n,              //  SDRAM Chip Select

  output            dram_ba_0,              //  SDRAM Bank Address 0

  output            dram_ba_1,              //  SDRAM Bank Address 0

  output            dram_clk,               //  SDRAM Clock

  output            dram_cke,               //  SDRAM Clock Enable

  ////////////////////////  Flash Interface ////////////////////////

  inout [7:0]       fl_dq,                  //  FLASH Data bus 8 Bits

  output    [21:0]  fl_addr,                //  FLASH Address bus 22 Bits

  output            fl_we_n,                //  FLASH Write Enable

  output            fl_rst_n,               //  FLASH Reset

  output            fl_oe_n,                //  FLASH Output Enable

  output            fl_ce_n,                //  FLASH Chip Enable

  ////////////////////////  SRAM Interface  ////////////////////////

  inout   [15:0]    sram_dq,                //  SRAM Data bus 16 Bits

  output  [17:0]    sram_addr,              //  SRAM Address bus 18 Bits

  output            sram_ub_n,              //  SRAM High-byte Data Mask 

  output            sram_lb_n,              //  SRAM Low-byte Data Mask 

  output            sram_we_n,              //  SRAM Write Enable

  output            sram_ce_n,              //  SRAM Chip Enable

  output            sram_oe_n,              //  SRAM Output Enable

  ////////////////////  SD Card Interface   ////////////////////////

  inout             sd_dat,                 //  SD Card Data

  inout             sd_dat3,                //  SD Card Data 3

  inout             sd_cmd,                 //  SD Card Command Signal

  output            sd_clk,                 //  SD Card Clock

  ////////////////////////  I2C     ////////////////////////////////

  inout             i2c_sdat,               //  I2C Data

  output            i2c_sclk,               //  I2C Clock

  ////////////////////////  PS2     ////////////////////////////////

  input             ps2_dat,                //  PS2 Data

  input             ps2_clk,                //  PS2 Clock

  ////////////////////  USB JTAG link   ////////////////////////////

  input             tdi,                    // CPLD -> FPGA (data in)

  input             tck,                    // CPLD -> FPGA (clk)

  input             tcs,                    // CPLD -> FPGA (CS)

  output            tdo,                    // FPGA -> CPLD (data out)

  ////////////////////////  VGA         ////////////////////////////

  output            vga_hs,                 //  VGA H_SYNC

  output            vga_vs,                 //  VGA V_SYNC

  output    [3:0]   vga_r,                  //  VGA Red[3:0]

  output    [3:0]   vga_g,                  //  VGA Green[3:0]

  output    [3:0]   vga_b,                  //  VGA Blue[3:0]

  ////////////////////  Audio CODEC     ////////////////////////////

  inout             aud_adclrck,            //  Audio CODEC ADC LR Clock

  input             aud_adcdat,             //  Audio CODEC ADC Data

  inout             aud_daclrck,            //  Audio CODEC DAC LR Clock

  output            aud_dacdat,             //  Audio CODEC DAC Data

  inout             aud_bclk,               //  Audio CODEC Bit-Stream Clock

  output            aud_xck,                //  Audio CODEC Chip Clock

  ////////////////////////  GPIO    ////////////////////////////////

  inout [35:0]      gpio_0,                 //  GPIO Connection 0

  inout [35:0]      gpio_1                  //  GPIO Connection 1

);

  //---------------------------------------------------

  // system wires

  wire        reset_switch  = ~key[0];

  wire [3:0]  boot_strap    = sw[3:0];

  wire        sysclk        = clock_24[0];

  //---------------------------------------------------

  // FLED

  reg [24:0] counter;

  wire [7:0]  fled;

  always @(posedge sysclk or posedge reset_switch)

    if(reset_switch)

      counter <= 25'b0;

    else

      counter <= counter + 1;

  assign fled[0]  = sw[0];

  assign fled[1]  = sw[1];

  assign fled[2]  = sw[2];

  assign fled[3]  = sw[3];

  assign fled[4]  = sw[4];

  assign fled[5]  = sw[5];

  assign fled[6]  = sw[6];

  assign fled[7]  = counter[24];

  //---------------------------------------------------

  // IO pads

  genvar i;

  // gpio a

  wire [31:0] gpio_a_aux_i;

  wire [31:0] gpio_a_ext_pad_i;

  wire [31:0] gpio_a_ext_pad_o;

  wire [31:0] gpio_a_ext_padoe_o;

  wire [31:0] gpio_a_io_buffer_o;

  generate for( i = 0; i < 32; i = i + 1 )

    begin: gpio_a_pads

      assign gpio_a_io_buffer_o[i] = gpio_a_ext_padoe_o[i] ? gpio_a_ext_pad_o[i] : 1'bz;

    end

  endgenerate

  //---------------------------------------------------

  // soc_top

`ifdef USE_DEBUG_0

  wire [255 : 0]  debug_0;

`endif

`ifdef USE_EXT_JTAG

  wire jtag_tck_i;

  wire jtag_tms_i;

  wire jtag_tdo_i;

  wire jtag_tdi_o;

`endif

  soc_top i_or1200_soc_top

  (

    .uart_txd_0(uart_txd),       //  UART Transmitter

    .uart_rxd_0(uart_rxd),       //  UART Receiver

    ////////////////////////  Flash Interface ////////////////////////

    .fl_dq(fl_dq),          //  flash data bus 8 bits

    .fl_addr(fl_addr),        //  flash address bus 22 bits

    .fl_we_n(fl_we_n),        //  flash write enable

    .fl_rst_n(fl_rst_n),       //  flash reset

    .fl_oe_n(fl_oe_n),        //  flash output enable

    .fl_ce_n(fl_ce_n),        //  flash chip enable

    ////////////////////////  sram interface  ////////////////////////

    .sram_dq(sram_dq),        //  sram data bus 16 bits

    .sram_addr(sram_addr),      //  sram address bus 18 bits

    .sram_ub_n(sram_ub_n),      //  sram high-byte data mask

    .sram_lb_n(sram_lb_n),      //  sram low-byte data mask

    .sram_we_n(sram_we_n),      //  sram write enable

    .sram_ce_n(sram_ce_n),      //  sram chip enable

    .sram_oe_n(sram_oe_n),      //  sram output enable

    .gpio_a_aux_i(gpio_a_aux_i),

    .gpio_a_ext_pad_i(gpio_a_ext_pad_i),

    .gpio_a_ext_pad_o(gpio_a_ext_pad_o),

    .gpio_a_ext_padoe_o(gpio_a_ext_padoe_o),

//     .gpio_b_aux_i(gpio_b_aux_i),   

//     .gpio_b_ext_pad_i(gpio_b_ext_pad_i), 

//     .gpio_b_ext_pad_o(gpio_b_ext_pad_o), 

//     .gpio_b_ext_padoe_o(gpio_b_ext_padoe_o), 

//     .gpio_c_aux_i(gpio_c_aux_i),   

//     .gpio_c_ext_pad_i(gpio_c_ext_pad_i), 

//     .gpio_c_ext_pad_o(gpio_c_ext_pad_o), 

//     .gpio_c_ext_padoe_o(gpio_c_ext_padoe_o), 

//     .gpio_d_aux_i(gpio_d_aux_i),   

//     .gpio_d_ext_pad_i(gpio_d_ext_pad_i), 

//     .gpio_d_ext_pad_o(gpio_d_ext_pad_o), 

//     .gpio_d_ext_padoe_o(gpio_d_ext_padoe_o), 

//     .gpio_e_aux_i(gpio_e_aux_i),   

//     .gpio_e_ext_pad_i(gpio_e_ext_pad_i), 

//     .gpio_e_ext_pad_o(gpio_e_ext_pad_o), 

//     .gpio_e_ext_padoe_o(gpio_e_ext_padoe_o), 

//     .gpio_f_aux_i(gpio_f_aux_i),   

//     .gpio_f_ext_pad_i(gpio_f_ext_pad_i), 

//     .gpio_f_ext_pad_o(gpio_f_ext_pad_o), 

//     .gpio_f_ext_padoe_o(gpio_f_ext_padoe_o), 

//     .gpio_g_aux_i(gpio_g_aux_i),   

//     .gpio_g_ext_pad_i(gpio_g_ext_pad_i), 

//     .gpio_g_ext_pad_o(gpio_g_ext_pad_o), 

//     .gpio_g_ext_padoe_o(gpio_g_ext_padoe_o), 

    .boot_strap(boot_strap),

`ifdef USE_DEBUG_0

    .debug_0(debug_0),

`endif

`ifdef USE_EXT_JTAG

    .jtag_tck_i(jtag_tck_i),

    .jtag_tms_i(jtag_tms_i),

    .jtag_tdo_i(jtag_tdo_i),

    .jtag_tdi_o(jtag_tdi_o),

`endif

    .sys_clk(sysclk),

    .sys_rst(reset_switch)

  );

  //---------------------------------------------------

  // outputs

  //  Turn off all display

  assign  hex0        =   7'hff;

  assign  hex1        =   7'hff;

  assign  hex2        =   7'hff;

  assign  hex3        =   7'hff;

//   assign  ledg        =   8'hff;

  assign  ledr        =   10'h000;

  //  All inout port turn to tri-state

  assign  dram_dq     =   16'hzzzz;

  assign  fl_dq       =   8'hzz;

//   assign  sram_dq     =   16'hzzzz;

  assign  sd_dat      =   1'bz;

  assign  i2c_sdat    =   1'bz;

  assign  aud_adclrck =   1'bz;

  assign  aud_daclrck =   1'bz;

  assign  aud_bclk    =   1'bz;

  assign  gpio_0      =   36'hzzzzzzzzz;

  assign  gpio_1      =   36'hzzzzzzzzz;

  assign ledg[7:0]        = gpio_a_io_buffer_o[7:0];

  assign gpio_a_aux_i     = { 24'h000000, fled };

  assign gpio_a_ext_pad_i = { 14'h0000, sw, ledg };

endmodule