Subversion Repositories or1k

#define DW 32   /* Data width of memory model generated by dumpverilog in bits */

#define DWQ (DW/8) /* Same as DW but units are bytes */

#define DISWIDTH 20 /* Width of disassembled message in bytes */

#define OR1K_MEM_VERILOG_HEADER(MODNAME, FROMADDR, TOADDR, DISWIDTH) "\n\

`include \"general.h\"\n\n\

`timescale 1ns/100ps\n\n\

// Simple dw-wide Sync SRAM with initial content generated by or1ksim.\n\

// All control, data in and addr signals are sampled at rising clock edge  \n\

// Data out is not registered. Address bits specify dw-word (narrowest \n\

// addressed data is not byte but dw-word !). \n

// There are still some bugs in generated output (dump word aligned regions)\n\n\

module %s(clk, data, addr, ce, we);\n\n\

parameter dw = 32;\n\

parameter amin = %d;\n\n\

parameter amax = %d;\n\n\

input clk;\n\

inout [dw-1:0] data;\n\

input [31:0] addr;\n\

input ce;\n\

input we;\n\n\

reg  [dw-1:0] mem [amax:amin];\n\

reg  [%d-1:0] dis [amax:amin];\n\

reg  [dw-1:0] dataout;\n\

tri  [dw-1:0] data = (ce && ~we) ? dataout : 'bz;\n\n\

initial begin\n", MODNAME, FROMADDR, TOADDR, DISWIDTH

#define OR1K_MEM_VERILOG_FOOTER "\n\

end\n\n\

always @(posedge clk) begin\n\

        if (ce && ~we) begin\n\

                dataout <= #1 mem[addr];\n\

                $display(\"or1k_mem: reading mem[%%0d]:%%h dis: %%0s\", addr, dataout, dis[addr]);\n\

        end else\n\

        if (ce && we) begin\n\

                mem[addr] <= #1 data;\n\

                dis[addr] <= #1 \"(data)\";\n\

                $display(\"or1k_mem: writing mem[%%0d]:%%h dis: %%0s\", addr, mem[addr], dis[addr]);\n\

        end\n\

end\n\n\

endmodule\n"