Subversion Repositories or1k

/* drivers/atm/midway.h - Efficient Networks Midway (SAR) description */

/* Written 1995-1999 by Werner Almesberger, EPFL LRC/ICA */

#ifndef DRIVERS_ATM_MIDWAY_H

#define DRIVERS_ATM_MIDWAY_H

#define NR_VCI          1024            /* number of VCIs */

#define NR_VCI_LD       10              /* log2(NR_VCI) */

#define NR_DMA_RX       512             /* RX DMA queue entries */

#define NR_DMA_TX       512             /* TX DMA queue entries */

#define NR_SERVICE      NR_VCI          /* service list size */

#define NR_CHAN         8               /* number of TX channels */

#define TS_CLOCK        25000000        /* traffic shaper clock (cell/sec) */

#define MAP_MAX_SIZE    0x00400000      /* memory window for max config */

#define EPROM_SIZE      0x00010000

#define MEM_VALID       0xffc00000      /* mask base address with this */

#define PHY_BASE        0x00020000      /* offset of PHY register are */

#define REG_BASE        0x00040000      /* offset of Midway register area */

#define RAM_BASE        0x00200000      /* offset of RAM area */

#define RAM_INCREMENT   0x00020000      /* probe for RAM every 128kB */

#define MID_VCI_BASE    RAM_BASE

#define MID_DMA_RX_BASE (MID_VCI_BASE+NR_VCI*16)

#define MID_DMA_TX_BASE (MID_DMA_RX_BASE+NR_DMA_RX*8)

#define MID_SERVICE_BASE (MID_DMA_TX_BASE+NR_DMA_TX*8)

#define MID_FREE_BASE   (MID_SERVICE_BASE+NR_SERVICE*4)

#define MAC_LEN 6 /* atm.h */

#define MID_MIN_BUF_SIZE (1024)         /*   1 kB is minimum */

#define MID_MAX_BUF_SIZE (128*1024)     /* 128 kB is maximum */

#define RX_DESCR_SIZE   1               /* RX PDU descr is 1 longword */

#define TX_DESCR_SIZE   2               /* TX PDU descr is 2 longwords */

#define AAL5_TRAILER    (ATM_AAL5_TRAILER/4) /* AAL5 trailer is 2 longwords */

#define TX_GAP          8               /* TX buffer gap (words) */

/*

 * Midway Reset/ID

 *

 * All values read-only. Writing to this register resets Midway chip.

 */

#define MID_RES_ID_MCON 0x00            /* Midway Reset/ID */

#define MID_ID          0xf0000000      /* Midway version */

#define MID_SHIFT       24

#define MID_MOTHER_ID   0x00000700      /* mother board id */

#define MID_MOTHER_SHIFT 8

#define MID_CON_TI      0x00000080      /* 0: normal ctrl; 1: SABRE */

#define MID_CON_SUNI    0x00000040      /* 0: UTOPIA; 1: SUNI */

#define MID_CON_V6      0x00000020      /* 0: non-pipel UTOPIA (required iff

                                           !CON_SUNI; 1: UTOPIA */

#define DAUGTHER_ID     0x0000001f      /* daugther board id */

/*

 * Interrupt Status Acknowledge, Interrupt Status & Interrupt Enable

 */

#define MID_ISA         0x01            /* Interrupt Status Acknowledge */

#define MID_IS          0x02            /* Interrupt Status */

#define MID_IE          0x03            /* Interrupt Enable */

#define MID_TX_COMPLETE_7 0x00010000    /* channel N completed a PDU */

#define MID_TX_COMPLETE_6 0x00008000    /* transmission */

#define MID_TX_COMPLETE_5 0x00004000

#define MID_TX_COMPLETE_4 0x00002000

#define MID_TX_COMPLETE_3 0x00001000

#define MID_TX_COMPLETE_2 0x00000800

#define MID_TX_COMPLETE_1 0x00000400

#define MID_TX_COMPLETE_0 0x00000200

#define MID_TX_COMPLETE 0x0001fe00      /* any TX */

#define MID_TX_DMA_OVFL 0x00000100      /* DMA to adapter overflow */

#define MID_TX_IDENT_MISM 0x00000080    /* TX: ident mismatch => halted */

#define MID_DMA_LERR_ACK 0x00000040     /* LERR - SBus ? */

#define MID_DMA_ERR_ACK 0x00000020      /* DMA error */

#define MID_RX_DMA_COMPLETE 0x00000010  /* DMA to host done */

#define MID_TX_DMA_COMPLETE 0x00000008  /* DMA from host done */

#define MID_SERVICE     0x00000004      /* something in service list */

#define MID_SUNI_INT    0x00000002      /* interrupt from SUNI */

#define MID_STAT_OVFL   0x00000001      /* statistics overflow */

/*

 * Master Control/Status

 */

#define MID_MC_S        0x04

#define MID_INT_SELECT  0x000001C0      /* Interrupt level (000: off) */

#define MID_INT_SEL_SHIFT 6

#define MID_TX_LOCK_MODE 0x00000020     /* 0: streaming; 1: TX ovfl->lock */

#define MID_DMA_ENABLE  0x00000010      /* R: 0: disable; 1: enable

                                           W: 0: no change; 1: enable */

#define MID_TX_ENABLE   0x00000008      /* R: 0: TX disabled; 1: enabled

                                           W: 0: no change; 1: enable */

#define MID_RX_ENABLE   0x00000004      /* like TX */

#define MID_WAIT_1MS    0x00000002      /* R: 0: timer not running; 1: running

                                           W: 0: no change; 1: no interrupts

                                                               for 1 ms */

#define MID_WAIT_500US  0x00000001      /* like WAIT_1MS, but 0.5 ms */

/*

 * Statistics

 *

 * Cleared when reading.

 */

#define MID_STAT                0x05

#define MID_VCI_TRASH   0xFFFF0000      /* trashed cells because of VCI mode */

#define MID_VCI_TRASH_SHIFT 16

#define MID_OVFL_TRASH  0x0000FFFF      /* trashed cells because of overflow */

/*

 * Address registers

 */

#define MID_SERV_WRITE  0x06    /* free pos in service area (R, 10 bits) */

#define MID_DMA_ADDR    0x07    /* virtual DMA address (R, 32 bits) */

#define MID_DMA_WR_RX   0x08    /* (RW, 9 bits) */

#define MID_DMA_RD_RX   0x09

#define MID_DMA_WR_TX   0x0A

#define MID_DMA_RD_TX   0x0B

/*

 * Transmit Place Registers (0x10+4*channel)

 */

#define MID_TX_PLACE(c) (0x10+4*(c))

#define MID_SIZE        0x00003800      /* size, N*256 x 32 bit */

#define MID_SIZE_SHIFT  11

#define MID_LOCATION    0x000007FF      /* location in adapter memory (word) */

#define MID_LOC_SKIP    8               /* 8 bits of location are always zero

                                           (applies to all uses of location) */

/*

 * Transmit ReadPtr Registers (0x11+4*channel)

 */

#define MID_TX_RDPTR(c) (0x11+4*(c))

#define MID_READ_PTR    0x00007FFF      /* next word for PHY */

/*

 * Transmit DescrStart Registers (0x12+4*channel)

 */

#define MID_TX_DESCRSTART(c) (0x12+4*(c))

#define MID_DESCR_START 0x00007FFF      /* seg buffer being DMAed */

#define ENI155_MAGIC    0xa54b872d

struct midway_eprom {

        unsigned char mac[MAC_LEN],inv_mac[MAC_LEN];

        unsigned char pad[36];

        u32 serial,inv_serial;

        u32 magic,inv_magic;

};

/*

 * VCI table entry

 */

#define MID_VCI_IN_SERVICE      0x00000001      /* set if VCI is currently in

                                                   service list */

#define MID_VCI_SIZE            0x00038000      /* reassembly buffer size,

                                                   2*<size> kB */

#define MID_VCI_SIZE_SHIFT      15

#define MID_VCI_LOCATION        0x1ffc0000      /* buffer location */

#define MID_VCI_LOCATION_SHIFT  18

#define MID_VCI_PTI_MODE        0x20000000      /* 0: trash, 1: preserve */

#define MID_VCI_MODE            0xc0000000

#define MID_VCI_MODE_SHIFT      30

#define MID_VCI_READ            0x00007fff

#define MID_VCI_READ_SHIFT      0

#define MID_VCI_DESCR           0x7fff0000

#define MID_VCI_DESCR_SHIFT     16

#define MID_VCI_COUNT           0x000007ff

#define MID_VCI_COUNT_SHIFT     0

#define MID_VCI_STATE           0x0000c000

#define MID_VCI_STATE_SHIFT     14

#define MID_VCI_WRITE           0x7fff0000

#define MID_VCI_WRITE_SHIFT     16

#define MID_MODE_TRASH  0

#define MID_MODE_RAW    1

#define MID_MODE_AAL5   2

/*

 * Reassembly buffer descriptor

 */

#define MID_RED_COUNT           0x000007ff

#define MID_RED_CRC_ERR         0x00000800

#define MID_RED_T               0x00001000

#define MID_RED_CE              0x00010000

#define MID_RED_CLP             0x01000000

#define MID_RED_IDEN            0xfe000000

#define MID_RED_SHIFT           25

#define MID_RED_RX_ID           0x1b            /* constant identifier */

/*

 * Segmentation buffer descriptor

 */

#define MID_SEG_COUNT           MID_RED_COUNT

#define MID_SEG_RATE            0x01f80000

#define MID_SEG_RATE_SHIFT      19

#define MID_SEG_PR              0x06000000

#define MID_SEG_PR_SHIFT        25

#define MID_SEG_AAL5            0x08000000

#define MID_SEG_ID              0xf0000000

#define MID_SEG_ID_SHIFT        28

#define MID_SEG_MAX_RATE        63

#define MID_SEG_CLP             0x00000001

#define MID_SEG_PTI             0x0000000e

#define MID_SEG_PTI_SHIFT       1

#define MID_SEG_VCI             0x00003ff0

#define MID_SEG_VCI_SHIFT       4

#define MID_SEG_TX_ID           0xb             /* constant identifier */

/*

 * DMA entry

 */

#define MID_DMA_COUNT           0xffff0000

#define MID_DMA_COUNT_SHIFT     16

#define MID_DMA_END             0x00000020

#define MID_DMA_TYPE            0x0000000f

#define MID_DT_JK       0x3

#define MID_DT_WORD     0x0

#define MID_DT_2W       0x7

#define MID_DT_4W       0x4

#define MID_DT_8W       0x5

#define MID_DT_16W      0x6

#define MID_DT_2WM      0xf

#define MID_DT_4WM      0xc

#define MID_DT_8WM      0xd

#define MID_DT_16WM     0xe

/* only for RX*/

#define MID_DMA_VCI             0x0000ffc0

#define MID_DMA_VCI_SHIFT       6

/* only for TX */

#define MID_DMA_CHAN            0x000001c0

#define MID_DMA_CHAN_SHIFT      6

#define MID_DT_BYTE     0x1

#define MID_DT_HWORD    0x2

#endif