Subversion Repositories or1k

/* $Id: aztcd.h,v 1.1.1.1 2004-04-15 02:18:50 phoenix Exp $

 *

 * Definitions for a AztechCD268 CD-ROM interface

 *      Copyright (C) 1994-98  Werner Zimmermann

 *

 *      based on Mitsumi CDROM driver by Martin Harriss

 *

 *  This program is free software; you can redistribute it and/or modify

 *  it under the terms of the GNU General Public License as published by

 *  the Free Software Foundation; either version 2 of the License, or

 *  (at your option) any later version.

 *

 *  This program is distributed in the hope that it will be useful,

 *  but WITHOUT ANY WARRANTY; without even the implied warranty of

 *  MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the

 *  GNU General Public License for more details.

 *

 *  You should have received a copy of the GNU General Public License

 *  along with this program; if not, write to the Free Software

 *  Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.

 *

 *  History:    W.Zimmermann adaption to Aztech CD268-01A Version 1.3

 *              October 1994 Email: Werner.Zimmermann@fht-esslingen.de

 */

/* *** change this to set the I/O port address of your CD-ROM drive,

       set to '-1', if you want autoprobing */

#define AZT_BASE_ADDR           -1

/* list of autoprobing addresses (not more than 15), last value must be 0x000

   Note: Autoprobing is only enabled, if AZT_BASE_ADDR is set to '-1' ! */

#define AZT_BASE_AUTO           { 0x320, 0x300, 0x310, 0x330, 0x000 }

/* Uncomment this, if your CDROM is connected to a Soundwave32-soundcard

   and configure AZT_BASE_ADDR and AZT_SW32_BASE_ADDR */

/*#define AZT_SW32 1

*/

#ifdef AZT_SW32 

#define AZT_SW32_BASE_ADDR      0x220  /*I/O port base address of your soundcard*/

#endif

/* Set this to 1, if you want your tray to be locked, set to 0 to prevent tray

   from locking */

#define AZT_ALLOW_TRAY_LOCK     1

/*Set this to 1 to allow auto-eject when unmounting a disk, set to 0, if you

  don't want the auto-eject feature*/

#define AZT_AUTO_EJECT          0

/*Set this to 1, if you want to use incompatible ioctls for reading in raw and

  cooked mode */

#define AZT_PRIVATE_IOCTLS      1

/*Set this to 1, if you want multisession support by the ISO fs. Even if you set

  this value to '0' you can use multisession CDs. In that case the drive's firm-

  ware will do the appropriate redirection automatically. The CD will then look

  like a single session CD (but nevertheless all data may be read). Please read

  chapter '5.1 Multisession support' in README.aztcd for details. Normally it's

  uncritical to leave this setting untouched */

#define AZT_MULTISESSION        1

/*Uncomment this, if you are using a linux kernel version prior to 2.1.0 */

/*#define AZT_KERNEL_PRIOR_2_1 */

/*---------------------------------------------------------------------------*/

/*-----nothing to be configured for normal applications below this line------*/

/* Increase this if you get lots of timeouts; if you get kernel panic, replace

   STEN_LOW_WAIT by STEN_LOW in the source code */

#define AZT_STATUS_DELAY        400       /*for timer wait, STEN_LOW_WAIT*/

#define AZT_TIMEOUT             8000000   /*for busy wait STEN_LOW, DTEN_LOW*/

#define AZT_FAST_TIMEOUT        10000     /*for reading the version string*/

/* number of times to retry a command before giving up */

#define AZT_RETRY_ATTEMPTS      3

/* port access macros */

#define CMD_PORT                azt_port

#define DATA_PORT               azt_port

#define STATUS_PORT             azt_port+1

#define MODE_PORT               azt_port+2

#ifdef  AZT_SW32                

 #define AZT_SW32_INIT          (unsigned int) (0xFF00 & (AZT_BASE_ADDR*16))

 #define AZT_SW32_CONFIG_REG    AZT_SW32_BASE_ADDR+0x16  /*Soundwave32 Config. Register*/

 #define AZT_SW32_ID_REG        AZT_SW32_BASE_ADDR+0x04  /*Soundwave32 ID Version Register*/

#endif

/* status bits */

#define AST_CMD_CHECK           0x80            /* 1 = command error */

#define AST_DOOR_OPEN           0x40            /* 1 = door is open */

#define AST_NOT_READY           0x20            /* 1 = no disk in the drive */

#define AST_DSK_CHG             0x02            /* 1 = disk removed or changed */

#define AST_MODE                0x01            /* 0=MODE1, 1=MODE2 */

#define AST_MODE_BITS           0x1C            /* Mode Bits */

#define AST_INITIAL             0x0C            /* initial, only valid ... */

#define AST_BUSY                0x04            /* now playing, only valid

                                                   in combination with mode

                                                   bits */

/* flag bits */

#define AFL_DATA                0x02            /* data available if low */

#define AFL_STATUS              0x04            /* status available if low */

#define AFL_OP_OK               0x01            /* OP_OK command correct*/

#define AFL_PA_OK               0x02            /* PA_OK parameter correct*/

#define AFL_OP_ERR              0x05            /* error in command*/

#define AFL_PA_ERR              0x06            /* error in parameters*/

#define POLLED                  0x04            /* polled mode */

/* commands */

#define ACMD_SOFT_RESET         0x10            /* reset drive */

#define ACMD_PLAY_READ          0x20            /* read data track in cooked mode */

#define ACMD_PLAY_READ_RAW      0x21            /* reading in raw mode*/

#define ACMD_SEEK               0x30            /* seek msf address*/

#define ACMD_SEEK_TO_LEADIN     0x31            /* seek to leadin track*/

#define ACMD_GET_ERROR          0x40            /* get error code */

#define ACMD_GET_STATUS         0x41            /* get status */

#define ACMD_GET_Q_CHANNEL      0x50            /* read info from q channel */

#define ACMD_EJECT              0x60            /* eject/open tray */

#define ACMD_CLOSE              0x61            /* close tray */

#define ACMD_LOCK               0x71            /* lock tray closed */

#define ACMD_UNLOCK             0x72            /* unlock tray */

#define ACMD_PAUSE              0x80            /* pause */

#define ACMD_STOP               0x81            /* stop play */

#define ACMD_PLAY_AUDIO         0x90            /* play audio track */

#define ACMD_SET_VOLUME         0x93            /* set audio level */

#define ACMD_GET_VERSION        0xA0            /* get firmware version */

#define ACMD_SET_DISK_TYPE      0xA1            /* set disk data mode */

#define MAX_TRACKS              104

struct msf {

        unsigned char   min;

        unsigned char   sec;

        unsigned char   frame;

};

struct azt_Play_msf {

        struct msf      start;

        struct msf      end;

};

struct azt_DiskInfo {

        unsigned char   first;

        unsigned char   next;

        unsigned char   last;

        struct msf      diskLength;

        struct msf      firstTrack;

        unsigned char   multi;

        struct msf      nextSession;

        struct msf      lastSession;

        unsigned char   xa;

        unsigned char   audio;

};

struct azt_Toc {

        unsigned char   ctrl_addr;

        unsigned char   track;

        unsigned char   pointIndex;

        struct msf      trackTime;

        struct msf      diskTime;

};