Subversion Repositories or1k_soc_on_altera_embedded_dev_kit

#

# Kconfig for uClinux(non-paged MM) depend configurations

# Hyok S. Choi 

#

config SET_MEM_PARAM

        bool "Set flash/sdram size and base addr"

        help

         Say Y to manually set the base addresses and sizes.

         otherwise, the default values are assigned.

config DRAM_BASE

        hex '(S)DRAM Base Address' if SET_MEM_PARAM

        default 0x00800000

config DRAM_SIZE

        hex '(S)DRAM SIZE' if SET_MEM_PARAM

        default 0x00800000

config FLASH_MEM_BASE

        hex 'FLASH Base Address' if SET_MEM_PARAM

        default 0x00400000

config FLASH_SIZE

        hex 'FLASH Size' if SET_MEM_PARAM

        default 0x00400000

config PROCESSOR_ID

        hex 'Hard wire the processor ID'

        default 0x00007700

        depends on !CPU_CP15

        help

          If processor has no CP15 register, this processor ID is

          used instead of the auto-probing which utilizes the register.

config REMAP_VECTORS_TO_RAM

        bool 'Install vectors to the begining of RAM' if DRAM_BASE

        depends on DRAM_BASE

        help

          The kernel needs to change the hardware exception vectors.

          In nommu mode, the hardware exception vectors are normally

          placed at address 0x00000000. However, this region may be

          occupied by read-only memory depending on H/W design.

          If the region contains read-write memory, say 'n' here.

          If your CPU provides a remap facility which allows the exception

          vectors to be mapped to writable memory, say 'n' here.

          Otherwise, say 'y' here.  In this case, the kernel will require

          external support to redirect the hardware exception vectors to

          the writable versions located at DRAM_BASE.