Subversion Repositories or1k_soc_on_altera_embedded_dev_kit

config MAC80211

        tristate "Generic IEEE 802.11 Networking Stack (mac80211)"

        depends on EXPERIMENTAL

        select CRYPTO

        select CRYPTO_ECB

        select CRYPTO_ARC4

        select CRYPTO_AES

        select CRC32

        select WIRELESS_EXT

        select CFG80211

        select NET_SCH_FIFO

        ---help---

        This option enables the hardware independent IEEE 802.11

        networking stack.

config MAC80211_RCSIMPLE

        bool "'simple' rate control algorithm" if EMBEDDED

        default y

        depends on MAC80211

        help

          This option allows you to turn off the 'simple' rate

          control algorithm in mac80211. If you do turn it off,

          you absolutely need another rate control algorithm.

          Say Y unless you know you will have another algorithm

          available.

config MAC80211_LEDS

        bool "Enable LED triggers"

        depends on MAC80211 && LEDS_TRIGGERS

        ---help---

        This option enables a few LED triggers for different

        packet receive/transmit events.

config MAC80211_DEBUGFS

        bool "Export mac80211 internals in DebugFS"

        depends on MAC80211 && DEBUG_FS

        ---help---

          Select this to see extensive information about

          the internal state of mac80211 in debugfs.

          Say N unless you know you need this.

config MAC80211_DEBUG

        bool "Enable debugging output"

        depends on MAC80211

        ---help---

          This option will enable debug tracing output for the

          ieee80211 network stack.

          If you are not trying to debug or develop the ieee80211

          subsystem, you most likely want to say N here.

config MAC80211_VERBOSE_DEBUG

        bool "Verbose debugging output"

        depends on MAC80211_DEBUG

config MAC80211_LOWTX_FRAME_DUMP

        bool "Debug frame dumping"

        depends on MAC80211_DEBUG

        ---help---

          Selecting this option will cause the stack to

          print a message for each frame that is handed

          to the lowlevel driver for transmission. This

          message includes all MAC addresses and the

          frame control field.

          If unsure, say N and insert the debugging code

          you require into the driver you are debugging.

config TKIP_DEBUG

        bool "TKIP debugging"

        depends on MAC80211_DEBUG

config MAC80211_DEBUG_COUNTERS

        bool "Extra statistics for TX/RX debugging"

        depends on MAC80211_DEBUG

config MAC80211_IBSS_DEBUG

        bool "Support for IBSS testing"

        depends on MAC80211_DEBUG

        ---help---

          Say Y here if you intend to debug the IBSS code.

config MAC80211_VERBOSE_PS_DEBUG

        bool "Verbose powersave mode debugging"

        depends on MAC80211_DEBUG

        ---help---

          Say Y here to print out verbose powersave

          mode debug messages.