Subversion Repositories plasma

---------------------------------------------------------------------

-- TITLE: Ethernet DMA

-- AUTHOR: Steve Rhoads (rhoadss@yahoo.com)

-- DATE CREATED: 12/27/07

-- FILENAME: eth_dma.vhd

-- PROJECT: Plasma CPU core

-- COPYRIGHT: Software placed into the public domain by the author.

--    Software 'as is' without warranty.  Author liable for nothing.

-- DESCRIPTION:

--    Ethernet DMA (Direct Memory Access) controller.  

--    Reads four bits and writes four bits from/to the Ethernet PHY each 

--    2.5 MHz clock cycle.  Received data is DMAed starting at 0x13ff0000 

--    transmit data is read from 0x13fd0000.

--    To send a packet write bytes/4 to Ethernet send register.

---------------------------------------------------------------------

library ieee;

use ieee.std_logic_1164.all;

use ieee.std_logic_unsigned.all;

use ieee.std_logic_arith.all;

use work.mlite_pack.all;

entity eth_dma is port(

   clk         : in std_logic;                      --25 MHz

   reset       : in std_logic;

   enable_eth  : in std_logic;                      --enable receive DMA

   select_eth  : in std_logic;

   rec_isr     : out std_logic;                     --data received

   send_isr    : out std_logic;                     --transmit done

   address     : out std_logic_vector(31 downto 2); --to DDR

   byte_we     : out std_logic_vector(3 downto 0);

   data_write  : out std_logic_vector(31 downto 0);

   data_read   : in std_logic_vector(31 downto 0);

   pause_in    : in std_logic;

   mem_address : in std_logic_vector(31 downto 2);  --from CPU

   mem_byte_we : in std_logic_vector(3 downto 0);

   data_w      : in std_logic_vector(31 downto 0);

   pause_out   : out std_logic;

   E_RX_CLK    : in std_logic;                      --2.5 MHz receive

   E_RX_DV     : in std_logic;                      --data valid

   E_RXD       : in std_logic_vector(3 downto 0);   --receive nibble

   E_TX_CLK    : in std_logic;                      --2.5 MHz transmit

   E_TX_EN     : out std_logic;                     --transmit enable

   E_TXD       : out std_logic_vector(3 downto 0)); --transmit nibble

end; --entity eth_dma

architecture logic of eth_dma is

   signal rec_clk    : std_logic_vector(1 downto 0);  --receive

   signal rec_valid  : std_logic;

   signal rec_latch  : std_logic_vector(3 downto 0);

   signal rec_store  : std_logic_vector(31 downto 0); --to DDR

   signal rec_data   : std_logic_vector(27 downto 0);

   signal rec_cnt    : std_logic_vector(2 downto 0);  --nibbles

   signal rec_words  : std_logic_vector(13 downto 0);

   signal rec_dma    : std_logic_vector(1 downto 0);  --active & request

   signal rec_done   : std_logic;

   signal send_clk   : std_logic_vector(1 downto 0);  --transmit

   signal send_read  : std_logic_vector(31 downto 0); --from DDR

   signal send_data  : std_logic_vector(31 downto 0);

   signal send_cnt   : std_logic_vector(2 downto 0);  --nibbles

   signal send_words : std_logic_vector(8 downto 0);

   signal send_level : std_logic_vector(8 downto 0);

   signal send_dma   : std_logic_vector(1 downto 0);  --active & request

   signal send_enable: std_logic;

begin  --architecture

   dma_proc: process(clk, reset, enable_eth, select_eth,

         data_read, pause_in, mem_address, mem_byte_we, data_w,

         E_RX_CLK, E_RX_DV, E_RXD, E_TX_CLK,

         rec_clk, rec_valid, rec_latch, rec_store, rec_data,

         rec_cnt, rec_words, rec_dma, rec_done,

         send_clk, send_read, send_data, send_cnt, send_words,

         send_level, send_dma, send_enable)

   begin

      if rising_edge(E_RX_CLK) then

         rec_valid <= E_RX_DV;

         rec_latch <= E_RXD;

      end if;

      if reset = '1' then

         rec_clk <= "00";

         rec_cnt <= "000";

         rec_words <= ZERO(13 downto 0);

         rec_dma <= "00";

         rec_done <= '0';

         send_clk <= "00";

         send_cnt <= "000";

         send_words <= ZERO(8 downto 0);

         send_level <= ZERO(8 downto 0);

         send_dma <= "00";

         send_enable <= '0';

      elsif rising_edge(clk) then

         --Receive nibble on low->high E_RX_CLK.  Send to DDR every 32 bits.

         rec_clk <= rec_clk(0) & E_RX_CLK;

         if rec_clk = "01" and enable_eth = '1' then

            if rec_valid = '1' or rec_cnt /= "000" then

               if rec_cnt = "111" then

                  rec_store <= rec_data & rec_latch;

                  rec_dma(0) <= '1';           --request DMA

               end if;

               rec_data <= rec_data(23 downto 0) & rec_latch;

               rec_cnt <= rec_cnt + 1;

            end if;

         end if;

         --Set transmit count or clear receive interrupt

         if select_eth = '1' then

            if mem_byte_we /= "0000" then

               send_cnt <= "000";

               send_words <= ZERO(8 downto 0);

               send_level <= data_w(8 downto 0);

               send_dma(0) <= '1';

            else

               rec_done <= '0';

            end if;

         end if;

         --Transmit nibble on low->high E_TX_CLK.  Get 32 bits from DDR.

         send_clk <= send_clk(0) & E_TX_CLK;

         if send_clk = "01" then

            if send_cnt = "111" then

               if send_words /= send_level then

                  send_data <= send_read;

                  send_dma(0) <= '1';

                  send_enable <= '1';

               else

                  send_enable <= '0';

               end if;

            else

               send_data(31 downto 4) <= send_data(27 downto 0);

            end if;

            send_cnt <= send_cnt + 1;

         end if;

         --Pick which type of DMA operation: bit0 = request; bit1 = active

         if pause_in = '0' then

            if rec_dma(1) = '1' then

               rec_dma <= "00";               --DMA done

               rec_words <= rec_words + 1;

               if rec_valid = '0' then

                  rec_done <= '1';

               end if;

            elsif send_dma(1) = '1' then

               send_dma <= "00";

               send_words <= send_words + 1;

               send_read <= data_read;

            elsif rec_dma(0) = '1' then

               rec_dma(1) <= '1';             --start DMA

            elsif send_dma(0) = '1' then

               send_dma(1) <= '1';            --start DMA

            end if;

         end if;

      end if;  --rising_edge(clk)

      E_TXD <= send_data(31 downto 28);

      E_TX_EN <= send_enable;

      rec_isr <= rec_done;

      if send_words = send_level then

         send_isr <= '1';

      else

         send_isr <= '0';

      end if;

      if rec_dma(1) = '1' then

         address <= "0001001111111111" & rec_words;        --0x13ff0000

         byte_we <= "1111";

         data_write <= rec_store;

         pause_out <= '1';                                 --to CPU

      elsif send_dma(1) = '1' then

         address <= "000100111111111000000" & send_words;  --0x13fe0000

         byte_we <= "0000";

         data_write <= data_w;

         pause_out <= '1';

      else

         address <= mem_address;  --Send request from CPU to DDR

         byte_we <= mem_byte_we;

         data_write <= data_w;

         pause_out <= '0';

      end if;

   end process;

end; --architecture logic