Subversion Repositories mips_enhanced

This leon3 design is tailored to the Altera NiosII Startix2

Development board, with 16-bit DDR SDRAM and 2 Mbyte of SSRAM.

As of this time, the DDR interface only works up to 120 MHz.

At 130 MHz, DDR data can be read but not written.

NOTE: the test bench cannot be simulated with DDR enabled

because the Altera pads do not have the correct delay models.

* The SMSC LAN91C111 10/100 Ethernet controller is attached

  to the I/O area of the memory controller at address 0x20000300.

  The ethernet interrupt is connected to GPIO[4], i.e. IRQ4.

* How to program the flash prom with a FPGA programming file

  1. Create a hex file of the programming file with Quartus.

  2. Convert it to srecord and adjust the load address:

        objcopy --adjust-vma=0x800000 output_file.hexout -O srec fpga.srec

  3. Program the flash memory using grmon:

      flash unlock all

      flash erase 0x800000 0xb00000

      flash load fpga.srec

* The SSRAM can be use if one waitstate is programmed in the memory controller.

  When using grmon, start with -ramws 1 .