OpenCores
URL https://opencores.org/ocsvn/zipcpu/zipcpu/trunk

Subversion Repositories zipcpu

[/] [zipcpu/] [trunk/] [rtl/] [peripherals/] [flashcache.v] - Blame information for rev 82

Go to most recent revision | Details | Compare with Previous | View Log

Line No. Rev Author Line
1 2 dgisselq
///////////////////////////////////////////////////////////////////////////
2
//
3
// Filename:    flashcache.v
4
//
5
// Project:     Zip CPU -- a small, lightweight, RISC CPU soft core
6
//
7
// Purpose:     Since my Zip CPU has primary access to a flash, which requires
8
//              nearly 24 clock cycles per read, this 'cache' module
9
//              is offered to minimize the effect.  The CPU may now request
10
//              some amount of flash to be copied into this on-chip RAM,
11
//              and then access it with nearly zero latency.
12
//
13 69 dgisselq
// Status:      This file is no longer being used as an active file within
14
//              the ZipCPU project.  It's an older file from an idea that 
15
//      never really caught traction.
16
//
17 2 dgisselq
// Interface:
18
//      FlashCache sits on the Wishbone bus as both a slave and a master.
19
//      Slave requests for memory will get mapped to a local RAM, from which
20
//      reads and writes may take place.
21
//
22
//      This cache supports a single control register: the base wishbone address
23
//      of the device to copy memory from.  The bottom bit if this address must
24
//      be zero (or it will be silently rendered as zero).  When read, this
25
//      bottom bit will indicate 1) that the controller is still loading memory
26
//      into the cache, or 0) that the cache is ready to be used.
27
//
28
//      Writing to this register will initiate a memory copy from the (new)
29
//      address.  Once done, the loading bit will be cleared and an interrupt
30
//      generated.
31
//
32
//      Where this memory is placed on the wishbone bus is entirely up to the
33
//              wishbone bus control logic.  Setting the memory base to an
34
//              address controlled by this flashcache will produce unusable
35
//              results, and may well hang the bus.
36
//      Reads from the memory before complete will return immediately with
37
//              the value if read address is less than the current copy
38
//              address, or else they will stall until the read address is
39
//              less than the copy address.
40
//
41
// Creator:     Dan Gisselquist, Ph.D.
42 69 dgisselq
//              Gisselquist Technology, LLC
43 2 dgisselq
//
44
///////////////////////////////////////////////////////////////////////////
45
//
46
// Copyright (C) 2015, Gisselquist Technology, LLC
47
//
48
// This program is free software (firmware): you can redistribute it and/or
49
// modify it under the terms of  the GNU General Public License as published
50
// by the Free Software Foundation, either version 3 of the License, or (at
51
// your option) any later version.
52
//
53
// This program is distributed in the hope that it will be useful, but WITHOUT
54
// ANY WARRANTY; without even the implied warranty of MERCHANTIBILITY or
55
// FITNESS FOR A PARTICULAR PURPOSE.  See the GNU General Public License
56
// for more details.
57
//
58
// License:     GPL, v3, as defined and found on www.gnu.org,
59
//              http://www.gnu.org/licenses/gpl.html
60
//
61
//
62
///////////////////////////////////////////////////////////////////////////
63
//
64
module  flashcache(i_clk,
65
                // Wishbone contrl interface
66
                i_wb_cyc, i_wb_stb,i_wb_ctrl_stb, i_wb_we, i_wb_addr, i_wb_data,
67
                        o_wb_ack, o_wb_stall, o_wb_data,
68
                // Wishbone copy interface
69
                o_cp_cyc, o_cp_stb, o_cp_we, o_cp_addr, o_cp_data,
70
                        i_cp_ack, i_cp_stall, i_cp_data,
71
                o_int);
72
        parameter       LGCACHELEN=10; // 4 kB
73
        input                   i_clk;
74
        // Control interface, CPU interface to cache
75
        input                   i_wb_cyc, i_wb_stb,i_wb_ctrl_stb, i_wb_we;
76
        input           [(LGCACHELEN-1):0]       i_wb_addr;
77
        input           [31:0]   i_wb_data;
78
        output  reg             o_wb_ack;
79
        output  wire            o_wb_stall;
80
        output  wire    [31:0]   o_wb_data;
81
        // Interface to peripheral bus, including flash
82
        output  reg             o_cp_cyc, o_cp_stb;
83
        output  wire            o_cp_we;
84
        output  reg     [31:0]   o_cp_addr;
85
        output  wire    [31:0]   o_cp_data;
86
        input                   i_cp_ack, i_cp_stall;
87
        input           [31:0]   i_cp_data;
88
        // And an interrupt to send once we complete
89
        output  reg             o_int;
90
 
91
        reg             loading;
92
        reg     [31:0]   cache_base;
93
        reg     [31:0]   cache   [0:((1<<LGCACHELEN)-1)];
94
 
95
        // Decouple writing the cache base from the highly delayed bus lines
96
        reg             wr_cache_base_flag;
97
        reg     [31:0]   wr_cache_base_value;
98
        always @(posedge i_clk)
99
                wr_cache_base_flag <= ((i_wb_cyc)&&(i_wb_ctrl_stb)&&(i_wb_we));
100
        always @(posedge i_clk)
101
                wr_cache_base_value<= { i_wb_data[31:1], 1'b0 };
102
 
103
        initial cache_base = 32'hffffffff;
104
        always @(posedge i_clk)
105
                if (wr_cache_base_flag)
106
                        cache_base <= wr_cache_base_value;
107
 
108
        reg     new_cache_base;
109
        initial new_cache_base = 1'b0;
110
        always @(posedge i_clk)
111
                if ((wr_cache_base_flag)&&(cache_base != wr_cache_base_value))
112
                        new_cache_base <= 1'b1;
113
                else
114
                        new_cache_base <= 1'b0;
115
 
116
        reg     [(LGCACHELEN-1):0]       rdaddr;
117
        initial loading = 1'b0;
118
        always @(posedge i_clk)
119
                if (new_cache_base)
120
                begin
121
                        loading <= 1'b1;
122
                        o_cp_cyc <= 1'b0;
123
                end else if ((~o_cp_cyc)&&(loading))
124
                begin
125
                        o_cp_cyc <= 1'b1;
126
                end else if (o_cp_cyc)
127
                begin
128
                        // Handle the ack/read line
129
                        if (i_cp_ack)
130
                        begin
131
                                if (&rdaddr)
132
                                begin
133
                                        o_cp_cyc <= 1'b0;
134
                                        loading <= 1'b0;
135
                                end
136
                        end
137
                end
138
        always @(posedge i_clk)
139
                if (~o_cp_cyc)
140
                        o_cp_addr <= cache_base;
141
                else if ((o_cp_cyc)&&(o_cp_stb)&&(~i_cp_stall))
142
                        o_cp_addr <= o_cp_addr + 1;;
143
        always @(posedge i_clk)
144
                if ((~o_cp_cyc)&&(loading))
145
                        o_cp_stb  <= 1'b1;
146
                else if ((o_cp_cyc)&&(o_cp_stb)&&(~i_cp_stall))
147
                begin
148
                        // We've made our last request
149
                        if (o_cp_addr >= cache_base + { {(32-LGCACHELEN-1){1'b0}}, 1'b1, {(LGCACHELEN){1'b0}}})
150
                                o_cp_stb <= 1'b0;
151
                end
152
        always @(posedge i_clk)
153
                if (~loading)
154
                        rdaddr    <= 0;
155
                else if ((o_cp_cyc)&&(i_cp_ack))
156
                        rdaddr <= rdaddr + 1;
157
 
158
        initial o_int = 1'b0;
159
        always @(posedge i_clk)
160
                if ((o_cp_cyc)&&(i_cp_ack)&&(&rdaddr))
161
                        o_int <= 1'b1;
162
                else
163
                        o_int <= 1'b0;
164
 
165
        assign  o_cp_we = 1'b0;
166
        assign  o_cp_data = 32'h00;
167
 
168
 
169
        //
170
        //      Writes to our cache ... always delayed by a clock.
171
        //              Clock 0 :       Write request
172
        //              Clock 1 :       Write takes place
173
        //              Clock 2 :       Available for reading
174
        //
175
        reg                             we;
176
        reg     [(LGCACHELEN-1):0]       waddr;
177
        reg     [31:0]                   wval;
178
        always @(posedge i_clk)
179
                we <= (loading)?((o_cp_cyc)&&(i_cp_ack)):(i_wb_cyc)&&(i_wb_stb)&&(i_wb_we);
180
        always @(posedge i_clk)
181
                waddr <= (loading)?rdaddr:i_wb_addr;
182
        always @(posedge i_clk)
183
                wval <= (loading)?i_cp_data:i_wb_data;
184
 
185
        always @(posedge i_clk)
186
                if (we)
187
                        cache[waddr] <= wval;
188
 
189
        reg     [31:0]   cache_data;
190
        always @(posedge i_clk)
191
                if ((i_wb_cyc)&&(i_wb_stb))
192
                        cache_data <= cache[i_wb_addr];
193
 
194
        always @(posedge i_clk)
195
                o_wb_ack <= (i_wb_cyc)&&(
196
                                ((i_wb_stb)&&(~loading))
197
                                ||(i_wb_ctrl_stb));
198
        reg     ctrl;
199
        always @(posedge i_clk)
200
                ctrl <= i_wb_ctrl_stb;
201
        assign  o_wb_data = (ctrl)?({cache_base[31:1],loading}):cache_data;
202
        assign  o_wb_stall = (loading)&&(~o_wb_ack);
203
 
204
endmodule

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.