URL
https://opencores.org/ocsvn/eco32/eco32/trunk
Subversion Repositories eco32
Compare Revisions
- This comparison shows the changes necessary to convert path
/eco32/trunk/fpga/mc/boards/s3e-500
- from Rev 290 to Rev 291
- ↔ Reverse comparison
Rev 290 → Rev 291
/build/eco32.bit
Cannot display: file marked as a binary type.
svn:mime-type = application/octet-stream
/doc/README
9,7 → 9,7
c) git clone git://git.zerfleddert.de/usb-driver |
d) cd usb-driver |
e) make |
f) ./setup_pcusb /opt/Xilinx/14.5/ISE_DS/ISE/ |
f) ./setup_pcusb /opt/Xilinx/14.7/ISE_DS/ISE/ |
|
2. The configuration bitstring for the FPGA is stored in the |
"Platform Flash PROM" (XCF04S). The board must therefore be |
17,7 → 17,7
|
3. Here is the command which burns the configuration bitstring |
into the Platform Flash PROM: |
/opt/Xilinx/14.5/ISE_DS/ISE/bin/lin/impact -batch ./program.cmd |
/opt/Xilinx/14.7/ISE_DS/ISE/bin/lin/impact -batch ./program.cmd |
|
4. The machine monitor is stored in the "StrataFlash Parallel NOR |
Flash PROM" (28F128J3), starting at address 0x000000. The ECO32 |
44,7 → 44,7
- add linefeed on (the programmer sends CR, but not LF) |
- local echo off (the programmer does echo itself) |
d) Here is the command that loads the FPGA with the programmer: |
/opt/Xilinx/14.5/ISE_DS/ISE/bin/lin/impact -batch ./flash-500.cmd |
/opt/Xilinx/14.7/ISE_DS/ISE/bin/lin/impact -batch ./flash-500.cmd |
If the download succeeds, you should see the message "PicoBlaze NOR |
FLASH Programmer v1.00" on the computer which is connected via the |
serial line to the starter board, as well as a menue of commands |