URL
https://opencores.org/ocsvn/i2clcd/i2clcd/trunk
Subversion Repositories i2clcd
Compare Revisions
- This comparison shows the changes necessary to convert path
/i2clcd/trunk/i2clcd/rtl
- from Rev 7 to Rev 8
- ↔ Reverse comparison
Rev 7 → Rev 8
/verilog/i2cgpio.v
0,0 → 1,64
// rtl program for i2c_gpio.v |
|
`define P0_P9_OP 4'b1010 //0x0A |
//`define P0_P3_OP 4'b1011 //0x0B |
`define P0_P3_OP 4'b0111 //0x07 |
`define P4_P7_OP 4'b1110 //0xE0 |
//`define P8_P9_OP 4'b1101 //0x0D |
|
module i2c_gpio(clk, cs, sr_in, sda_out, sr_out, gpio); |
|
input clk,cs; |
input sr_in; |
output sda_out; |
output sr_out; |
output [7:0] gpio; |
|
reg [7:0] sr; |
reg [7:0] addrreg; |
reg sda_out; |
reg sr_out ; |
reg [7:0] gpio; |
reg [7:0] ram; |
wire [3:0] addr; |
wire [3:0] data; |
|
assign addr = sr[3:0]; |
assign data = sr[7:4]; |
always@(posedge clk) |
begin |
if (cs == 1'b0) |
begin |
sr_out <= sr[7]; |
sr[7:1] <= sr[6:0]; |
sr[0] <= sr_in; |
end |
begin |
if (addr[0] == 1'b0) // low bit zero - start bit |
begin |
if(addr[3:0] == 4'h0E) // 0xD is the address of the slave |
begin |
sda_out = 1'b1; // high bit for Acknowledge to master |
if(addr[3]== 1'b1) // high bit for write |
begin |
case (addr[3:0]) // data[3:0] for data write |
// `P0_P9_OP : gpio[7:4] <= {sr[0], sr[1], sr[2], sr[3], sr[4], sr[5], sr[6], sr[7]}; |
`P0_P3_OP : gpio[3:0] <= {data[0], data[1], data[2], data[3]}; |
`P4_P7_OP : gpio[3:0] <= {data[3], data[2], data[1], data[0]}; |
// `P8_P9_OP : gpio[9:8] <= {sr[0], sr[0]}; |
// default : gpio[7:0] <= {sr[0], sr[0], sr[0], sr[0], |
// sr[0], sr[0], sr[0], sr[0]}; |
endcase |
sda_out = 1'b1; // high bit for Acknowledge master |
end |
else |
begin |
sda_out = 1'bz; |
end |
end |
end |
end |
end |
endmodule |
|
|