URL
https://opencores.org/ocsvn/ssbcc/ssbcc/trunk
Go to most recent revision |
Show entire file |
Details |
Blame |
View Log
Rev 6 |
Rev 9 |
Line 28... |
Line 28... |
outsignal=o_name
|
outsignal=o_name
|
specifies the name of the output signal
|
specifies the name of the output signal
|
Note: The name must start with "o_".
|
Note: The name must start with "o_".
|
ratemethod={clk/rate|count}
|
ratemethod={clk/rate|count}
|
specifies the frequency at which the PWM counter is incremented
|
specifies the frequency at which the PWM counter is incremented
|
|
Note: "clk," "rate," and "count" can be integers or can be declared by
|
|
CONSTANT, LOCALPARARM, or PARAMETER configuration commands.
|
Example: ratemethod=count means to increment the PWM counter once every
|
Example: ratemethod=count means to increment the PWM counter once every
|
"count" clock cycles.
|
"count" clock cycles.
|
|
Example: ratemethod=G_CLK_HZ/1_000 means to use the parameter G_CLK_HZ
|
|
(set elsewhere) and a 1,000 Hz update rate to determine the
|
|
number of clock cycles between updates.
|
invert|noinvert
|
invert|noinvert
|
optional configuration command to invert or to not invert the PWM output
|
optional configuration command to invert or to not invert the PWM output
|
Default: don't invert the output (i.e., a command of 0 means the output is
|
Default: don't invert the output (i.e., a command of 0 means the output is
|
always low)
|
always low)
|
Note: "invert" should be used when pulling the external signal to ground
|
Note: "invert" should be used when pulling the external signal to ground
|
© copyright 1999-2024
OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.