Line 1... |
Line 1... |
# $Id: w11a_os_guide.txt 442 2011-12-23 10:03:28Z mueller $
|
# $Id: w11a_os_guide.txt 469 2013-01-05 12:29:44Z mueller $
|
|
|
Guide to run operating system images on w11a systems
|
Guide to run operating system images on w11a systems
|
|
|
Table of content:
|
Table of content:
|
|
|
Line 50... |
Line 50... |
- load the w11a design into the FPGA, e.g. via impact
|
- load the w11a design into the FPGA, e.g. via impact
|
|
|
3. Unix V5 system ---------------------------------------------------------
|
3. Unix V5 system ---------------------------------------------------------
|
|
|
- A disk set is available from
|
- A disk set is available from
|
http://www-linux.gsi.de/~mueller/retro/oc_w11/data/unix_v5_rkset.tgz
|
http://www.retro11.de/data/oc_w11/unix_v5_rkset.tgz
|
Download, unpack and copy the disk images (*.dsk) to
|
Download, unpack and copy the disk images (*.dsk) to
|
$RETROBASE/rtl/sys_gen/w11a/tb
|
$RETROBASE/rtl/sys_gen/w11a/tb
|
|
|
- Setup USB-RS232 cable, start xterm in vt100 mode and the server backend
|
- Setup USB-RS232 cable, start xterm in vt100 mode and the server backend
|
Note: It is essential that the settings of the board switches are correct
|
Note: It is essential that the settings of the board switches are correct
|
Line 95... |
Line 95... |
There is no 'halt' or 'shutdown' command, just ^D out of the server
|
There is no 'halt' or 'shutdown' command, just ^D out of the server
|
session. The disks aren't cached, so no need to sync either.
|
session. The disks aren't cached, so no need to sync either.
|
|
|
4. 2.11BSD system ---------------------------------------------------------
|
4. 2.11BSD system ---------------------------------------------------------
|
- A disk set is available from
|
- A disk set is available from
|
http://www-linux.gsi.de/~mueller/retro/oc_w11/data/211bsd_rkset.tgz
|
http://www.retro11.de/data/oc_w11/211bsd_rkset.tgz
|
Download, unpack and copy the disk images (*.dsk) to
|
Download, unpack and copy the disk images (*.dsk) to
|
$RETROBASE/rtl/sys_gen/w11a/tb
|
$RETROBASE/rtl/sys_gen/w11a/tb
|
|
|
- Setup USB-RS232 cable, start two xterm in vt100 mode and the server backend
|
- Setup USB-RS232 cable, start two xterm in vt100 mode and the server backend
|
Note: It is essential that the settings of the board switches are correct
|
Note: It is essential that the settings of the board switches are correct
|