URL
https://opencores.org/ocsvn/w11/w11/trunk
[/] [w11/] [tags/] [w11a_V0.7/] [doc/] [INSTALL.txt] - Diff between revs 19 and 20
Go to most recent revision |
Show entire file |
Details |
Blame |
View Log
Rev 19 |
Rev 20 |
Line 1... |
Line 1... |
# $Id: INSTALL.txt 504 2013-04-13 15:37:24Z mueller $
|
# $Id: INSTALL.txt 511 2013-04-27 13:51:46Z mueller $
|
|
|
Guide to install and build w11a systems, test benches and support software
|
Guide to install and build w11a systems, test benches and support software
|
|
|
Table of content:
|
Table of content:
|
|
|
Line 309... |
Line 309... |
|
|
To load the bitfile with WebPack impact into the target board use
|
To load the bitfile with WebPack impact into the target board use
|
|
|
make .iconfig
|
make .iconfig
|
|
|
|
For boards with a Cypress FX2 USB controller load the bitfile directly with
|
|
|
|
make .jconfig
|
|
|
If only the xst or par output is wanted just use
|
If only the xst or par output is wanted just use
|
|
|
make .ngc
|
make .ngc
|
make .ncd
|
make .ncd
|
|
|
Line 334... |
Line 338... |
For Xilinx Impact a Xilinx USB Cable II has to be properly setup, than
|
For Xilinx Impact a Xilinx USB Cable II has to be properly setup, than
|
simply use
|
simply use
|
|
|
make .iconfig
|
make .iconfig
|
|
|
For using the Cypress FX2 USB controlle on Digilent Nexys2, Nexys3 and
|
For using the Cypress FX2 USB controller on Digilent Nexys2, Nexys3 and
|
Atlys boards just connect the USB cable and
|
Atlys boards just connect the USB cable and
|
|
|
make .jconfig
|
make .jconfig
|
|
|
This will automatically check and optionaly re-load the FX2 firmware
|
This will automatically check and optionaly re-load the FX2 firmware
|
© copyright 1999-2024
OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.