| Line 46... |
Line 46... |
* @name User configuration
|
* @name User configuration
|
**************************************************************************/
|
**************************************************************************/
|
/**@{*/
|
/**@{*/
|
/** UART BAUD rate */
|
/** UART BAUD rate */
|
#define BAUD_RATE 19200
|
#define BAUD_RATE 19200
|
|
/** Use the custom ASM version for blinking the LEDs if != 0 */
|
|
#define USE_ASM_VERSION 0
|
/**@}*/
|
/**@}*/
|
|
|
|
|
/**********************************************************************//**
|
/**********************************************************************//**
|
|
* ASM function to blink LEDs (if enabled)
|
|
**************************************************************************/
|
|
extern void blink_led_asm(uint32_t gpio_out_addr);
|
|
|
|
|
|
/**********************************************************************//**
|
* Main function; shows an incrementing 8-bit counter on GPIO.output(7:0).
|
* Main function; shows an incrementing 8-bit counter on GPIO.output(7:0).
|
*
|
*
|
* @note This program requires the GPIO controller to be synthesized (the UART is optional).
|
* @note This program requires the GPIO controller to be synthesized (the UART is optional).
|
*
|
*
|
* @return Irrelevant.
|
* @return Irrelevant.
|
| Line 74... |
Line 82... |
neorv32_rte_setup();
|
neorv32_rte_setup();
|
|
|
// say hello
|
// say hello
|
neorv32_uart_print("Blinking LED demo program\n");
|
neorv32_uart_print("Blinking LED demo program\n");
|
|
|
|
|
|
// use C version of LED blinking
|
|
#if (USE_ASM_VERSION == 0)
|
|
|
neorv32_gpio_port_set(0); // clear gpio output put
|
neorv32_gpio_port_set(0); // clear gpio output put
|
|
|
int cnt = 0;
|
int cnt = 0;
|
|
|
while (1) {
|
while (1) {
|
neorv32_gpio_port_set(cnt++ & 0xFF); // increment counter and mask for lowest 8 bit
|
neorv32_gpio_port_set(cnt++ & 0xFF); // increment counter and mask for lowest 8 bit
|
neorv32_cpu_delay_ms(200); // wait 200ms using busy wait
|
neorv32_cpu_delay_ms(200); // wait 200ms using busy wait
|
}
|
}
|
|
|
|
// use ASM version of LED blinking (file: blink_led_in_asm.S)
|
|
#else
|
|
|
|
blink_led_asm((uint32_t)(&GPIO_OUTPUT));
|
|
|
|
#endif
|
return 0;
|
return 0;
|
}
|
}
|
|
|
No newline at end of file
|
No newline at end of file
|
