URL
https://opencores.org/ocsvn/usb_fpga_1_11/usb_fpga_1_11/trunk
Subversion Repositories usb_fpga_1_11
[/] [usb_fpga_1_11/] [trunk/] [examples/] [usb-fpga-1.15y/] [intraffic/] [intraffic.c] - Rev 6
Go to most recent revision | Compare with Previous | Blame | View Log
/*! intraffic -- example showing how the EZ-USB FIFO interface is used on ZTEX USB-FPGA Module 1.15b Copyright (C) 2009-2011 ZTEX GmbH. http://www.ztex.de This program is free software; you can redistribute it and/or modify it under the terms of the GNU General Public License version 3 as published by the Free Software Foundation. This program is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for more details. You should have received a copy of the GNU General Public License along with this program; if not, see http://www.gnu.org/licenses/. !*/ #include[ztex-conf.h] // Loads the configuration macros, see ztex-conf.h for the available macros #include[ztex-utils.h] // include basic functions // configure endpoint 2, in, quad buffered, 512 bytes, interface 0 EP_CONFIG(2,0,BULK,IN,512,4); // configure endpoint 6, out, doublebuffered, 512 bytes, interface 0 EP_CONFIG(6,0,BULK,OUT,512,2); // select ZTEX USB FPGA Module 1.15 as target (required for FPGA configuration) IDENTITY_UFM_1_15Y(10.15.0.0,0); // this product string is also used for identification by the host software #define[PRODUCT_STRING]["intraffic example for UFM 1.15y"] // enables high speed FPGA configuration via EP6 ENABLE_HS_FPGA_CONF(6); // this is called automatically after FPGA configuration #define[POST_FPGA_CONFIG][POST_FPGA_CONFIG IOA0 = 1; // controlled mode IOA7 = 1; // reset on OEA = bmBIT0 | bmBIT7; EP2CS &= ~bmBIT0; // clear stall bit REVCTL = 0x1; SYNCDELAY; IFCONFIG = bmBIT7 | bmBIT5 | 3; // internal IFCLK, 30 MHz, OE, slave FIFO interface SYNCDELAY; EP2FIFOCFG = bmBIT3 | bmBIT0; // AOTUOIN, WORDWIDE SYNCDELAY; EP2AUTOINLENH = 2; // 512 bytes SYNCDELAY; EP2AUTOINLENL = 0; SYNCDELAY; FIFORESET = 0x80; // reset FIFO SYNCDELAY; FIFORESET = 2; SYNCDELAY; FIFORESET = 0x00; SYNCDELAY; FIFOPINPOLAR = 0; SYNCDELAY; PINFLAGSAB = 0; SYNCDELAY; PINFLAGSCD = 0; SYNCDELAY; IOA7 = 0; // reset off ] // set mode ADD_EP0_VENDOR_COMMAND((0x60,, IOA7 = 1; // reset on IOA0 = SETUPDAT[2] ? 1 : 0; IOA7 = 0; // reset off ,, NOP; ));; // include the main part of the firmware kit, define the descriptors, ... #include[ztex.h] void main(void) { init_USB(); while (1) { } }
Go to most recent revision | Compare with Previous | Blame | View Log