URL
https://opencores.org/ocsvn/amber/amber/trunk
Subversion Repositories amber
[/] [amber/] [trunk/] [sw/] [boot-loader-ethmac/] [ethmac.c] - Rev 69
Go to most recent revision | Compare with Previous | Blame | View Log
/*---------------------------------------------------------------- // // // boot-loader-ethmac.c // // // // This file is part of the Amber project // // http://www.opencores.org/project,amber // // // // Description // // The main functions for the boot loader application. This // // application is embedded in the FPGA's SRAM and is used // // to load larger applications into the DDR3 memory on // // the development board. // // // // Author(s): // // - Conor Santifort, csantifort.amber@gmail.com // // // ////////////////////////////////////////////////////////////////// // // // Copyright (C) 2011 Authors and OPENCORES.ORG // // // // This source file may be used and distributed without // // restriction provided that this copyright statement is not // // removed from the file and that any derivative work contains // // the original copyright notice and the associated disclaimer. // // // // This source file is free software; you can redistribute it // // and/or modify it under the terms of the GNU Lesser General // // Public License as published by the Free Software Foundation; // // either version 2.1 of the License, or (at your option) any // // later version. // // // // This source is distributed in the hope that it will be // // useful, but WITHOUT ANY WARRANTY; without even the implied // // warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR // // PURPOSE. See the GNU Lesser General Public License for more // // details. // // // // You should have received a copy of the GNU Lesser General // // Public License along with this source; if not, download it // // from http://www.opencores.org/lgpl.shtml // // // ----------------------------------------------------------------*/ #include "amber_registers.h" #include "address_map.h" #include "timer.h" #include "utilities.h" #include "line-buffer.h" #include "packet.h" #include "ethmac.h" void close_link (void) { /* Disable EthMac interrupts in Ethmac core */ *(unsigned int *) ( ADR_ETHMAC_INT_MASK ) = 0x0; /* Disable Ethmac interrupt in interrupt controller */ *(unsigned int *) ( ADR_AMBER_IC_IRQ0_ENABLECLR ) = 0x100; /* Disable Rx & Tx - MODER Register [15] = Add pads to short frames [13] = CRCEN [10] = Enable full duplex [7] = loopback [5] = 1 for promiscuous, 0 rx only frames that match mac address [1] = txen [0] = rxen */ *(unsigned int *) ( ADR_ETHMAC_MODER ) = 0xa420; /* Put the PHY into reset */ phy_rst(0); /* reset is active low */ } /* return 1 if link comes up */ int open_link (void) { int packet; int n; unsigned int d32; /* Disable Ethmac interrupt in interrupt controller */ *(unsigned int *) ( ADR_AMBER_IC_IRQ0_ENABLECLR ) = 0x100; /* Set my MAC address */ d32 = self_g.mac[2]<<24|self_g.mac[3]<<16|self_g.mac[4]<<8|self_g.mac[5]; *(unsigned int *) ( ADR_ETHMAC_MAC_ADDR0 ) = d32; d32 = self_g.mac[0]<<8|self_g.mac[1]; *(unsigned int *) ( ADR_ETHMAC_MAC_ADDR1 ) = d32; if (!config_phy()) return 0; /* Write the Receive Packet Buffer Descriptor */ /* Buffer Pointer */ for (packet=0; packet<ETHMAC_RX_BUFFERS; packet++) { *(unsigned int *) ( ADR_ETHMAC_BDBASE + 0x204 + packet*8 ) = ETHMAC_RX_BUFFER + packet * 0x1000; /* Ready Rx buffer [31:16] = length in bytes, [15] = empty [14] = Enable IRQ [13] = wrap bit */ /* set empty flag again */ if (packet == ETHMAC_RX_BUFFERS-1) /* last receive buffer ? */ /* Set wrap bit is last buffer */ *(unsigned int *) ( ADR_ETHMAC_BDBASE + 0x200 + packet*8 ) = 0x0000e000; else *(unsigned int *) ( ADR_ETHMAC_BDBASE + 0x200 + packet*8 ) = 0x0000c000; } /* Enable EthMac interrupts in Ethmac core */ /* Receive frame and receive error botgh enabled */ /* When a bad frame is received is still gets written to a buffer so needs to be dealt with */ *(unsigned int *) ( ADR_ETHMAC_INT_MASK ) = 0xc; /* Enable Ethmac interrupt in interrupt controller */ *(unsigned int *) ( ADR_AMBER_IC_IRQ0_ENABLESET ) = 0x100; /* Set transmit packet buffer location */ *(unsigned int *) ( ADR_ETHMAC_BDBASE + 4 ) = ETHMAC_TX_BUFFER; /* Set the ready bit, bit 15, low */ *(unsigned int *) ( ADR_ETHMAC_BDBASE + 0 ) = 0x7800; /* Enable Rx & Tx - MODER Register [15] = Add pads to short frames [13] = CRCEN [10] = Enable full duplex [7] = loopback [5] = 1 for promiscuous, 0 rx only frames that match mac address [1] = txen [0] = rxen */ *(unsigned int *) ( ADR_ETHMAC_MODER ) = 0xa423; return 1; } void tx_packet(int len) { unsigned int status = 0; /* Poll the ready bit. Wait until the ready bit is cleared by the ethmac hardware This holds everything up while the packet is being transmitted, but it keeps things simple. */ status = *(volatile unsigned int *) ( ADR_ETHMAC_BDBASE + 0 ); while ((status & 0x8000) != 0) { udelay20(); status = *(volatile unsigned int *) ( ADR_ETHMAC_BDBASE + 0 ); } /* Enable packet tx [31:16] = length in bytes, [15] = ready [14] = tx int [13] = wrap bit [12] = pad enable for short packets [11] = crc en */ *(unsigned int *) ( ADR_ETHMAC_BDBASE + 0 ) = len<<16 | 0xf800; } /* returns 1 if link comes up */ int config_phy (void) { int addr; int bmcr; int stat; int phy_id; int link_up = 1; time_t* link_timer; link_timer = init_timer(); /* Bring PHY out of reset */ phy_rst(1); /* reset is active low */ /* Discover phy addr by searching addrs in order {1,0,2,..., 31} */ for(addr = 0; addr < 32; addr++) { phy_id = (addr == 0) ? 1 : (addr == 1) ? 0 : addr; bmcr = mdio_read(phy_id, MII_BMCR); /* Basic Mode Control Register */ stat = mdio_read(phy_id, MII_BMSR); stat = mdio_read(phy_id, MII_BMSR); if(!((bmcr == 0xFFFF) || ((stat == 0) && (bmcr == 0)))) break; } /* Reset PHY */ bmcr = mdio_read(phy_id, MII_BMCR); mdio_write(phy_id, MII_BMCR, bmcr | BMCR_RESET); /* Advertise that PHY is NOT B1000-T capable */ /* Set bits 9.8, 9.9 to 0 */ bmcr = mdio_read(phy_id, MII_CTRL1000); mdio_write(phy_id, MII_CTRL1000, bmcr & 0xfcff ); /* Restart autoneg */ bmcr = mdio_read(phy_id, MII_BMCR); mdio_write(phy_id, MII_BMCR, bmcr | BMCR_ANRESTART); /* Wait for link up */ /* Print PHY status MII_BMSR = Basic Mode Status Register*/ /* allow 2 seconds for the link to come up before giving up */ set_timer(link_timer, 5000); while (!((stat = mdio_read(phy_id, MII_BMSR)) & BMSR_LSTATUS)) { if (timer_expired(link_timer)) { link_up = 0; break; } } return link_up; } int mdio_read(int addr, int reg) { return mdio_ctrl(addr, mdi_read, reg, 0); } void mdio_write(int addr, int reg, int data) { mdio_ctrl(addr, mdi_write, reg, data); } /* addr = PHY address reg = register address within PHY */ unsigned short mdio_ctrl(unsigned int addr, unsigned int dir, unsigned int reg, unsigned short data) { unsigned int data_out = 0; unsigned int i; unsigned long flags; mdio_ready(); *(volatile unsigned int *)(ADR_ETHMAC_MIIADDRESS) = (reg << 8) | (addr & 0x1f); if (dir == mdi_write) { *(volatile unsigned int *)(ADR_ETHMAC_MIITXDATA) = data; /* Execute Write ! */ *(volatile unsigned int *)(ADR_ETHMAC_MIICOMMAND) = 0x4; } else { /* Execute Read ! */ *(volatile unsigned int *)(ADR_ETHMAC_MIICOMMAND) = 0x2; mdio_ready(); data_out = *(volatile unsigned int *)(ADR_ETHMAC_MIIRXDATA); } return (unsigned short) data_out; } /* Wait until its ready */ void mdio_ready() { int i; for (;;) { /* Bit 1 is high when the MD i/f is busy */ if ((*(volatile unsigned int *)(ADR_ETHMAC_MIISTATUS) & 0x2) == 0x0) break; i++; if (i==10000000) { i=0; } } } void ethmac_interrupt(void) { int buffer; unsigned int int_src; unsigned int rx_buf_status; /* Mask ethmac interrupts */ *(volatile unsigned int *) ( ADR_ETHMAC_INT_MASK ) = 0; int_src = *(volatile unsigned int *) ( ADR_ETHMAC_INT_SOURCE ); for (buffer=0; buffer<ETHMAC_RX_BUFFERS; buffer++) { rx_buf_status = *(volatile unsigned int *) ( ADR_ETHMAC_BDBASE + 0x200 + buffer*8 ); if ((rx_buf_status & 0x8000) == 0) { parse_rx_packet((char*)(ETHMAC_RX_BUFFER+buffer*0x1000), rx_packet_g); /* set empty flag again */ if (buffer == ETHMAC_RX_BUFFERS-1) /* last receive buffer ? */ *(unsigned int *) ( ADR_ETHMAC_BDBASE + 0x200 + buffer*8 ) = 0x0000e000; else *(unsigned int *) ( ADR_ETHMAC_BDBASE + 0x200 + buffer*8 ) = 0x0000c000; } } /* Clear all ethmac interrupts */ *(volatile unsigned int *) ( ADR_ETHMAC_INT_SOURCE ) = int_src; /* UnMask ethmac interrupts */ *(volatile unsigned int *) ( ADR_ETHMAC_INT_MASK ) = 0xc; }
Go to most recent revision | Compare with Previous | Blame | View Log