Subversion Repositories darkriscv

/*
 * Copyright (c) 2018, Marcelo Samsoniuk
 * All rights reserved.
 * 
 * Redistribution and use in source and binary forms, with or without
 * modification, are permitted provided that the following conditions are met:
 * 
 * * Redistributions of source code must retain the above copyright notice, this
 *   list of conditions and the following disclaimer.
 * 
 * * Redistributions in binary form must reproduce the above copyright notice,
 *   this list of conditions and the following disclaimer in the documentation
 *   and/or other materials provided with the distribution.
 * 
 * * Neither the name of the copyright holder nor the names of its
 *   contributors may be used to endorse or promote products derived from
 *   this software without specific prior written permission.
 * 
 * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS"
 * AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
 * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE
 * DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE
 * FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
 * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR
 * SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER
 * CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY,
 * OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
 * OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. 
 */
 
`timescale 1ns / 1ps
`include "../rtl/config.vh"
 
// clock and reset logic
 
module darksimv;
 
    reg CLK = 0;
 
    reg RES = 1;
 
    initial while(1) #(500e6/`BOARD_CK) CLK = !CLK; // clock generator w/ freq defined by config.vh
 
    initial
    begin
        $display("reset (startup)");
        #1e3    RES = 0;            // wait 1us in reset state
        //#1000e3 RES = 1;            // run  1ms
        //$display("reset (restart)");
        //#1e3    RES = 0;            // wait 1us in reset state
        //#1000e3 $finish();          // run  1ms
    end
 
    wire TX;
    wire RX = 1;
 
    darksocv darksocv
    (
        .XCLK(CLK),
        .XRES(|RES),
        .UART_RXD(RX),
        .UART_TXD(TX)
    );
 
endmodule