URL
https://opencores.org/ocsvn/ft816float/ft816float/trunk
Subversion Repositories ft816float
[/] [ft816float/] [trunk/] [rtl/] [verilog2/] [DFPRound.sv] - Rev 76
Go to most recent revision | Compare with Previous | Blame | View Log
// ============================================================================
// __
// \\__/ o\ (C) 2006-2020 Robert Finch, Waterloo
// \ __ / All rights reserved.
// \/_// robfinch<remove>@finitron.ca
// ||
//
// DFPRound.sv
// - decimal floating point rounding unit
// - parameterized width
// - IEEE 754 representation
//
//
// BSD 3-Clause License
// Redistribution and use in source and binary forms, with or without
// modification, are permitted provided that the following conditions are met:
//
// 1. Redistributions of source code must retain the above copyright notice, this
// list of conditions and the following disclaimer.
//
// 2. Redistributions in binary form must reproduce the above copyright notice,
// this list of conditions and the following disclaimer in the documentation
// and/or other materials provided with the distribution.
//
// 3. Neither the name of the copyright holder nor the names of its
// contributors may be used to endorse or promote products derived from
// this software without specific prior written permission.
//
// THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS"
// AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
// IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE
// DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE
// FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
// DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR
// SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER
// CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY,
// OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
// OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
//
// ============================================================================
import fp::*;
`ifdef MIN_LATENCY
`define PIPE_ADV *
`else
`define PIPE_ADV (posedge clk)
`endif
module DFPRound(clk, ce, rm, i, o);
parameter N=33;
input clk;
input ce;
input [2:0] rm; // rounding mode
input [N*4+16+4+4-1:0] i; // intermediate format input
output [N*4+16+4-1:0] o; // rounded output
parameter ROUND_CEILING = 3'd0;
parameter ROUND_FLOOR = 3'd1;
parameter ROUND_HALF_UP = 3'd2;
parameter ROUND_HALF_EVEN = 3'd3;
parameter ROUND_DOWN = 3'd4;
//------------------------------------------------------------
// variables
wire [3:0] so;
wire [15:0] xo;
reg [N*4-1:0] mo;
reg [15:0] xo1;
reg [N*4-1:0] mo1;
wire xInf = i[N*4+16+4-1:(N+1)*4]==16'h9999;
wire so0 = i[N*4+16+4-2];
assign o = {so,xo,mo};
wire [3:0] l = i[7:4];
wire [3:0] r = i[3:0];
reg rnd;
//------------------------------------------------------------
// Clock #1
// - determine round amount (add 1 or 0)
//------------------------------------------------------------
always @`PIPE_ADV
if (ce) xo1 <= i[N*4+16+4-1:(N+1)*4];
always @`PIPE_ADV
if (ce) mo1 <= i[(N+1)*4-1:4];
// Compute the round bit
// Infinities and NaNs are not rounded!
always @`PIPE_ADV
if (ce)
if (|so[1:0])
rnd = 1'b0;
else
case (rm)
ROUND_CEILING: rnd <= (r == 4'd0 || so[2]==1'b0) ? 1'b0 : 1'b1;
ROUND_FLOOR: rnd <= (r == 4'd0 || so[2]==1'b1) ? 1'b0 : 1'b1;
ROUND_HALF_UP: rnd <= r >= 4'h5;
ROUND_HALF_EVEN: rnd <= r==4'h5 ? l[0] : r > 4'h5 ? 1'b1 : 1'b0;
ROUND_DOWN: rnd <= 1'b0;
default: rnd <= 1'b0;
endcase
//------------------------------------------------------------
// Clock #2
// round the number, check for carry
// note: inf. exponent checked above (if the exponent was infinite already, then no rounding occurs as rnd = 0)
// note: exponent increments if there is a carry (can only increment to infinity)
//------------------------------------------------------------
wire [N*4+16+4-1-4:0] rounded1;
wire co1;
BCDAddN #(.N(N+4)) ubcdan1
(
.ci(1'b0),
.a({xo1,mo1}),
.b({{N*4+16+4-1-4{1'd0}},rnd}),
.o(rounded1),
.co(co1)
);
reg [N*4+16+4-1-4:0] rounded2;
reg carry2;
reg rnd2;
reg dn2;
wire [15:0] xo2;
always @`PIPE_ADV
if (ce) rounded2 <= rounded1;
always @`PIPE_ADV
if (ce) carry2 <= co1;
always @`PIPE_ADV
if (ce) rnd2 <= rnd;
always @`PIPE_ADV
if (ce) dn2 <= !(|xo1);
assign xo2 = rounded2[N*4+16+4-1-4:N*4];
//------------------------------------------------------------
// Clock #3
// - shift mantissa if required.
//------------------------------------------------------------
`ifdef MIN_LATENCY
assign so = i[N*4+16+4+3:N*4+16+4];
assign xo = xo2;
`else
delay3 #(4) u21 (.clk(clk), .ce(ce), .i(i[N*4+16+4+3:N*4+16+4]), .o(so));
delay1 #(16) u22 (.clk(clk), .ce(ce), .i(xo2), .o(xo));
`endif
always @`PIPE_ADV
if (ce)
casez({rnd2,xo2==16'h9999,carry2,dn2})
4'b0??0: mo <= mo1[N*4-1:0]; // not rounding, not denormalized
4'b0??1: mo <= mo1[N*4-1:0]; // not rounding, denormalized
4'b1000: mo <= rounded2[N*4-1: 0]; // exponent didn't change, number was normalized
4'b1001: mo <= rounded2[N*4-1: 0]; // exponent didn't change, but number was denormalized
4'b1010: mo <= {4'h1,rounded2[N*4-1: 4]}; // exponent incremented (new MSD generated), number was normalized
4'b1011: mo <= rounded2[N*4-1:0]; // exponent incremented (new MSB generated), number was denormalized, number became normalized
4'b11??: mo <= {N*4{1'd0}}; // number became infinite, no need to check carry etc., rnd would be zero if input was NaN or infinite
endcase
endmodule
Go to most recent revision | Compare with Previous | Blame | View Log