URL
https://opencores.org/ocsvn/ht_tunnel/ht_tunnel/trunk
Subversion Repositories ht_tunnel
[/] [ht_tunnel/] [trunk/] [rtl/] [systemc/] [reordering_l2/] [fetch_packet_l3.cpp] - Rev 19
Compare with Previous | Blame | View Log
//fetch_packet_l3.cpp /* ***** BEGIN LICENSE BLOCK ***** * Version: MPL 1.1 * * The contents of this file are subject to the Mozilla Public License Version * 1.1 (the "License"); you may not use this file except in compliance with * the License. You may obtain a copy of the License at * http://www.mozilla.org/MPL/ * * Software distributed under the License is distributed on an "AS IS" basis, * WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License * for the specific language governing rights and limitations under the * License. * * The Original Code is HyperTransport Tunnel IP Core. * * The Initial Developer of the Original Code is * Ecole Polytechnique de Montreal. * Portions created by the Initial Developer are Copyright (C) 2005 * the Initial Developer. All Rights Reserved. * * Contributor(s): * Ami Castonguay <acastong@grm.polymtl.ca> * * Alternatively, the contents of this file may be used under the terms * of the Polytechnique HyperTransport Tunnel IP Core Source Code License * (the "PHTICSCL License", see the file PHTICSCL.txt), in which case the * provisions of PHTICSCL License are applicable instead of those * above. If you wish to allow use of your version of this file only * under the terms of the PHTICSCL License and not to allow others to use * your version of this file under the MPL, indicate your decision by * deleting the provisions above and replace them with the notice and * other provisions required by the PHTICSCL License. If you do not delete * the provisions above, a recipient may use your version of this file * under either the MPL or the PHTICSCL License." * * ***** END LICENSE BLOCK ***** */ #include "fetch_packet_l3.h" fetch_packet_l3::fetch_packet_l3(sc_module_name name) : sc_module(name){ SC_METHOD(register_signals); sensitive_pos(clk); sensitive_neg(resetx); SC_METHOD(select_and_ack_packet); for(int destination = 0; destination < 2; destination++){ sensitive << posted_available[destination] << nposted_available[destination] << response_available[destination] << posted_requested[destination] << nposted_requested[destination] << response_requested[destination] << posted_packet_addr[destination] << nposted_packet_addr[destination] << response_packet_addr[destination]; } SC_METHOD(reconstruct_packet); sensitive << command_packet_rd_data_ro[0] << command_packet_rd_data_ro[1] #ifdef ENABLE_REORDERING << packet_passpw[0] << packet_passpw[1] << packet_seqid[0] << packet_seqid[1] << packet_chain[0] << packet_chain[1] #endif << packet_vc[0] << packet_vc[0] << packet_fetched[0] << packet_fetched[1]; } void fetch_packet_l3::select_and_ack_packet(){ for(int destination = 0; destination < 2; destination++){ sc_uint<LOG2_NB_OF_BUFFERS+2> ro_command_packet_rd_addr_tmp; //Some default values for outputs ack_posted[destination] = false; ack_nposted[destination] = false; ack_response[destination] = false; selected_vc[destination] = VC_NONE; packet_selected[destination] = false; ro_command_packet_rd_addr_tmp = 0; //Retrieve posted packets first, if there is a packet of that type available //and it is being requested if(posted_requested[destination].read() && posted_available[destination].read()){ ack_posted[destination] = true; selected_vc[destination] = VC_POSTED; packet_selected[destination] = true; ro_command_packet_rd_addr_tmp.range(LOG2_NB_OF_BUFFERS+1,LOG2_NB_OF_BUFFERS) = VC_POSTED; ro_command_packet_rd_addr_tmp.range(LOG2_NB_OF_BUFFERS-1,0) = posted_packet_addr[destination]; } //Then responses else if(response_requested[destination].read() && response_available[destination].read()){ ack_response[destination] = true; selected_vc[destination] = VC_RESPONSE; packet_selected[destination] = true; ro_command_packet_rd_addr_tmp.range(LOG2_NB_OF_BUFFERS+1,LOG2_NB_OF_BUFFERS) = VC_RESPONSE; ro_command_packet_rd_addr_tmp.range(LOG2_NB_OF_BUFFERS-1,0) = response_packet_addr[destination]; } //Finally nposted packets else if(nposted_requested[destination].read() && nposted_available[destination].read()){ ack_nposted[destination] = true; selected_vc[destination] = VC_NON_POSTED; packet_selected[destination] = true; ro_command_packet_rd_addr_tmp.range(LOG2_NB_OF_BUFFERS+1,LOG2_NB_OF_BUFFERS) = VC_NON_POSTED; ro_command_packet_rd_addr_tmp.range(LOG2_NB_OF_BUFFERS-1,0) = nposted_packet_addr[destination]; } //Output the result ro_command_packet_rd_addr[destination] = ro_command_packet_rd_addr_tmp; } } void fetch_packet_l3::register_signals(){ if(!resetx.read()){ for(int destination = 0; destination < 2; destination++){ #ifdef ENABLE_REORDERING packet_passpw[destination] = false; packet_seqid[destination] = 0; packet_chain[destination] = false; #else currently_posted_chain[destination] = false; #endif packet_vc[destination] = VC_NONE; packet_fetched[destination] = false; } } else{ for(int destination = 0; destination < 2; destination++){ //Register the decision from the other combinatorial process packet_vc[destination] = selected_vc[destination].read(); packet_fetched[destination] = packet_selected[destination].read(); #ifdef ENABLE_REORDERING //Register information about the packet depending on the virtual channel //of the packet switch(selected_vc[destination].read()){ case VC_NON_POSTED: packet_passpw[destination] = nposted_packet_passpw[destination].read(); packet_seqid[destination] = nposted_packet_seqid[destination].read(); packet_chain[destination] = false; break; case VC_RESPONSE: packet_passpw[destination] = response_packet_passpw[destination].read(); packet_seqid[destination] = 0; packet_chain[destination] = false; break; default: packet_passpw[destination] = posted_packet_passpw[destination].read(); packet_seqid[destination] = posted_packet_seqid[destination].read(); packet_chain[destination] = posted_packet_chain[destination].read(); } #else if(packet_vc[destination].read() == VC_POSTED) currently_posted_chain[destination] = (sc_bit)command_packet_rd_data_ro[destination].read()[19]; #endif } } } void fetch_packet_l3::reconstruct_packet(){ //The role of this function is to reconstruct packets for output by merging //the information coming from the buffers and the information from the //embedded memory. The reconstruction is exactly the inverse of what was //done in the entrance reordering. There is a better explanation about what //is going on in that module (entrance reordering) if it is needed to understand //this code. for(int destination = 0; destination < 2; destination++){ fetched_packet_available[destination] = packet_fetched[destination]; fetched_packet_vc[destination] = packet_vc[destination]; syn_ControlPacketComplete fetched_packet_tmp; //A default value, might be mofidied below depending on preprocessor directives fetched_packet_tmp.packet = command_packet_rd_data_ro[destination].read().range(63,0); #ifndef ENABLE_REORDERING bool posted_part_of_chain = packet_vc[destination].read() == VC_POSTED && ((sc_bit)command_packet_rd_data_ro[destination].read()[19] || (sc_bit)currently_posted_chain[destination].read()); fetched_packet_tmp.error64BitExtension = (sc_bit)command_packet_rd_data_ro[destination].read()[64]; fetched_packet_tmp.data_address = (sc_bv<BUFFERS_ADDRESS_WIDTH>)command_packet_rd_data_ro[destination].read().range(LOG2_NB_OF_BUFFERS+64,65); fetched_packet_tmp.isPartOfChain = posted_part_of_chain; if(destination == FWD_DEST){ fetched_packet_nposted_refid[destination] = (sc_bv<LOG2_NB_OF_BUFFERS+1>)command_packet_rd_data_ro[destination].read().range(LOG2_NB_OF_BUFFERS+BUFFERS_ADDRESS_WIDTH+65,BUFFERS_ADDRESS_WIDTH+65); fetched_packet_response_refid[destination] = (sc_bv<LOG2_NB_OF_BUFFERS+1>)command_packet_rd_data_ro[destination].read().range(2 * LOG2_NB_OF_BUFFERS+BUFFERS_ADDRESS_WIDTH+66,LOG2_NB_OF_BUFFERS+BUFFERS_ADDRESS_WIDTH+66); } else{ fetched_packet_nposted_refid[destination] = (sc_bv<LOG2_NB_OF_BUFFERS+1>)command_packet_rd_data_ro[destination].read().range(3*LOG2_NB_OF_BUFFERS+BUFFERS_ADDRESS_WIDTH+67,2*LOG2_NB_OF_BUFFERS+BUFFERS_ADDRESS_WIDTH+67); fetched_packet_response_refid[destination] = (sc_bv<LOG2_NB_OF_BUFFERS+1>)command_packet_rd_data_ro[destination].read().range(4 * LOG2_NB_OF_BUFFERS+BUFFERS_ADDRESS_WIDTH+68,3*LOG2_NB_OF_BUFFERS+BUFFERS_ADDRESS_WIDTH+68); } #else //Recover error64bit at passPW position fetched_packet_tmp.error64BitExtension = (sc_bit)command_packet_rd_data_ro[destination].read()[15]; fetched_packet_tmp.packet[15] = packet_passpw[destination].read(); //Recover the refid if(packet_vc[destination].read() == VC_POSTED){ fetched_packet_nposted_refid[destination] = posted_packet_nposted_refid[destination]; fetched_packet_response_refid[destination] = posted_packet_response_refid[destination]; } else{ //If the packet is NPOSTED, only the nposted_refid will be read //If the packet is RESPONSE, only the response_refid will be read //This is why we output the same thing for both values (simplifies logic) #if BUFFERS_ADDRESS_WIDTH < 5 fetched_packet_nposted_refid[destination] = (sc_bv<LOG2_NB_OF_BUFFERS+1>)command_packet_rd_data_ro[destination].read().range(LOG2_NB_OF_BUFFERS+64,64); fetched_packet_response_refid[destination] = (sc_bv<LOG2_NB_OF_BUFFERS+1>)command_packet_rd_data_ro[destination].read().range(LOG2_NB_OF_BUFFERS+64,64); #else fetched_packet_nposted_refid[destination] = (sc_bv<LOG2_NB_OF_BUFFERS+1>)command_packet_rd_data_ro[destination].read().range(60+LOG2_NB_OF_BUFFERS + BUFFERS_ADDRESS_WIDTH,60+BUFFERS_ADDRESS_WIDTH); fetched_packet_response_refid[destination] = (sc_bv<LOG2_NB_OF_BUFFERS+1>)command_packet_rd_data_ro[destination].read().range(60+LOG2_NB_OF_BUFFERS + BUFFERS_ADDRESS_WIDTH,60+BUFFERS_ADDRESS_WIDTH); #endif } //For other field, place differently depending on if it is a response or not if(packet_vc[destination].read() == VC_RESPONSE){ fetched_packet_tmp.packet.range(5,2) = "1100"; #if BUFFERS_ADDRESS_WIDTH < 5 fetched_packet_tmp.data_address = (sc_bv<BUFFERS_ADDRESS_WIDTH>)command_packet_rd_data_ro[destination].read().range(1 + BUFFERS_ADDRESS_WIDTH,2); #else fetched_packet_tmp.data_address.range(3,0) = command_packet_rd_data_ro[destination].read().range(5,2); fetched_packet_tmp.data_address.range(BUFFERS_ADDRESS_WIDTH-1,4) = command_packet_rd_data_ro[destination].read().range(27 + BUFFERS_ADDRESS_WIDTH,32); #endif } else{ // -seqID is sent to registers : bits 7..6 and 14..13 #if BUFFERS_ADDRESS_WIDTH < 3 fetched_packet_tmp.data_address = (sc_bv<BUFFERS_ADDRESS_WIDTH>)command_packet_rd_data_ro[destination].read().range(BUFFERS_ADDRESS_WIDTH+5,6); fetched_packet_tmp.packet.range(7,6) = packet_seqid[destination].read().range(3,2); #elif BUFFERS_ADDRESS_WIDTH < 5 fetched_packet_tmp.data_address.range(1,0) = (sc_bv<2>)command_packet_rd_data_ro[destination].read().range(7,6); fetched_packet_tmp.packet.range(7,6) = packet_seqid[destination].read().range(3,2); fetched_packet_tmp.data_address.range(BUFFERS_ADDRESS_WIDTH-1,2) = (sc_bv<BUFFERS_ADDRESS_WIDTH-2>)command_packet_rd_data_ro[destination].read().range(BUFFERS_ADDRESS_WIDTH+10,13); fetched_packet_tmp.packet.range(14,13) = packet_seqid[destination].read().range(1,0); #else fetched_packet_tmp.data_address.range(1,0) = (sc_bv<2>)command_packet_rd_data_ro[destination].read().range(7,6); fetched_packet_tmp.packet.range(7,6) = packet_seqid[destination].read().range(3,2); fetched_packet_tmp.data_address.range(3,2) = command_packet_rd_data_ro[destination].read().range(14,13); fetched_packet_tmp.packet.range(14,13) = packet_seqid[destination].read().range(1,0); fetched_packet_tmp.data_address.range(BUFFERS_ADDRESS_WIDTH-1,4) = command_packet_rd_data_ro[destination].read().range(59+BUFFERS_ADDRESS_WIDTH,64); #endif } #endif fetched_packet[destination] = fetched_packet_tmp; } }