Subversion Repositories mips_enhanced

SDRAM controller enable
CONFIG_DDR2SP
  Say Y here to enabled a 16-bit DDR266 SDRAM controller. 

Power-on init
CONFIG_DDR2SP_INIT
  Say Y here to enable the automatic DDR initialization sequence.
  If disabled, the sequencemust be performed in software before
  the DDR can be used. If unsure, say Y.

Memory frequency
CONFIG_DDR2SP_FREQ
  Enter the frequency of the DDR clock (in MHz). The value is
  typically between 130 - 200, depending on system configuration.
  Some template design (such as the leon3-avnet-eval-lx25)
  calculate this value automatically and this value is not used.

Refresh to Activate
CONFIG_DDR2SP_TRFC
  Enter the Refresh to Activate timing (tRFC) in ns. The value is
  typically between 75 - 130, depending on memory chip implementation.

DDR2 Data width
CONFIG_DDR2SP_DATAWIDTH
  Select the width of the DDR2 data bus. 64-bit or 32-bit or
  16-bit can be selected. Only used in some template designs.

Column bits
CONFIG_DDR2SP_COL
  Select the number of colomn address bits of the DDR memory.
  Typical values are 8 - 11. Only needed when automatic DDR
  initialisation is choosen. The column size can always be
  programmed by software as well.

Chip select size
CONFIG_DDR2SP_MBYTE
  Select the memory size (Mbytes) that each chip select should decode.
  Only needed when automatic DDR initialisation is choosen. The chip
  select size can always be programmed by software as well.

Read data delay
CONFIG_DDR2SP_DELAY0 CONFIG_DDR2SP_DELAY1 CONFIG_DDR2SP_DELAY2 CONFIG_DDR2SP_DELAY3 CONFIG_DDR2SP_DELAY4 CONFIG_DDR2SP_DELAY5 CONFIG_DDR2SP_DELAY6 CONFIG_DDR2SP_DELAY7
  On Xilinx targets (virtex4 and virtex5), input delays are added to 
  all data bits to align read data to the internal DDR clock signal.
  The delay can be set to a value of 0 to 63 tap-delays. Each tap- 
  delay equals to ~78ps delay, with an reference clock at 200 MHz. 
  This delay value is only a reset valus, it can be changed dynamically 
  via a configuration register.